Professional & Technical Services · Grand Rapids, MI

Steel Supply & Engineering

According to OSHA enforcement records (2010–2026), Steel Supply & Engineering ranks #78,662 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 7 violations across 2 inspections.

Lower half by penalty100% serious
$1,775
OSHA penalties
7
Violations cited
2
OSHA inspections
#78,662
of 99,447 penalized employers

Steel Supply & Engineering in Grand Rapids, MI has been the subject of 2 OSHA workplace inspections and 7 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $1,775. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Steel Supply & Engineering 2 times over 1 year - more than twice a year on average. These inspections resulted in 7 violations, averaging 3.5 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #78,662 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 7 were classified as serious - indicating hazards that could cause death or serious harm. Against the Professional & Technical Services industry average of 1 inspections per employer, this runs well above peers (3.4x the sector average) on inspection frequency. For comparison, IMIH Group LLC in Novi, MI is another professional & technical services employer with 0 OSHA inspections on record and $0 in current penalties.

3.5
violations per inspection
100.0%
of violations were serious
#78,662
of 99,447 penalized employers

Compliance score

F 39/100
  • F OSHA safety compliance: 7 violations across 2 OSHA inspections (3.5 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How Steel Supply & Engineering compares on OSHA penalties

Total current penalty vs the Professional & Technical Services per-employer average

in penalties

What this shows Steel Supply & Engineering runs moderately above peers (1.3x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$1,775 Top 21% most affordable more affordable than 79% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). This entry sits in this band. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Above this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Above this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Professional & Technical Services employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Steel Supply & Engineering.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both1.92.022.02.004.79.414.218.9OSHA inspectionsViolations citedALPHA TESTING, INC., OSHA inspections: 2 · Violations cited: 1J - LEN T'S, OSHA inspections: 2 · Violations cited: 7CALSPAN CORPORATION, OSHA inspections: 2 · Violations cited: 3RANDY CARFAGNO PRODU…, OSHA inspections: 2 · Violations cited: 7BASF, OSHA inspections: 2 · Violations cited: 2MCMINN COUNTY - AIRP…, OSHA inspections: 2 · Violations cited: 8MCCLELLAND LABORATOR…, OSHA inspections: 2 · Violations cited: 1THE PET CLINIC PC, OSHA inspections: 2 · Violations cited: 3PAE APPLIED TECHNOLO…, OSHA inspections: 2 · Violations cited: 18FULFILLMENT AMERICA,…, OSHA inspections: 2 · Violations cited: 7GEOLOGICAL SURVEY FR…, OSHA inspections: 2 · Violations cited: 8ICF INTERNATIONAL, OSHA inspections: 2 · Violations cited: 0FULL STEAM STAFFING, OSHA inspections: 2 · Violations cited: 0UNIS LLC, OSHA inspections: 2 · Violations cited: 7VCA VETERINARY SPECI…, OSHA inspections: 2 · Violations cited: 0ALL-TOWN, INCORPORATED, OSHA inspections: 2 · Violations cited: 2ANAN INVESTMENTS, INC., OSHA inspections: 2 · Violations cited: 24PX EXPRESS USA, OSHA inspections: 2 · Violations cited: 9ADAMS OUTDOOR ADVERT…, OSHA inspections: 2 · Violations cited: 1WESTROC TRUCKING INC, OSHA inspections: 2 · Violations cited: 1Steel Supply & Engin…, OSHA inspections: 2 · Violations cited: 7
Steel Supply & Engineering has 2 OSHA inspections on record and 7 violations cited. The crosshair marks the median among these Professional & Technical Services peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Steel Supply & Engineering in the Professional & Technical Services enforcement ledger

Professional & Technical Services sector: Steel Supply & Engineering is the #365 heaviest OSHA penalty carrier of 509 employers with nonzero fines ($1,775).

How Steel Supply & Engineering Compares

Steel Supply & Engineering's 3.50 violations per inspection compares to the Professional & Technical Services sector average of 1.2 violations per employer.

Against the Professional & Technical Services industry average of $1,358 per employer, this employer's current OSHA penalty runs moderately above peers (1.3x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

2

First Inspection

2015-10-29

Last Inspection

2015-12-15

Inspection Span

1 yr

Violations / Inspection

3.5

Avg Penalty / Inspection

$888

Industry Avg / Inspection

$2,331

What this shows 2 inspections over 1 year, averaging 3.5 violations per visit. That's $888 per inspection vs. the Professional & Technical Services average of $2,331.

Enforcement detail

Violation Breakdown

7

Serious

100.0% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

0

Other-Than-Serious

0.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$11,050

Current Penalty Amount

$1,775

Penalty Reduction

83.9%

What this shows Penalties were reduced by $9,275 from the initial assessment of $11,050. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Professional & Technical Services

How Steel Supply & Engineering compares to the Professional & Technical Services sector, which has 3,597 employers tracked by PlainWorker.

Metric Steel Supply & Engineering Industry Avg
Inspections 2 0.6
Violations 7 1.2
Total Penalty $1,775 $1,358
Avg Penalty per Inspection $888 $2,331

Nationwide Professional & Technical Services peers with similar penalties or inspection counts

Two OSHA-record peer sets for Steel Supply & Engineering, both outside MI so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($1,775 here).

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Nearby & Similar Employers in Professional & Technical Services

Showing 5 of 3596 other employers tracked in this sector.

Compare Steel Supply & Engineering vs Apex Systems, LLC (NV, OK, OR) side-by-side →

What to do with this record

Use Steel Supply & Engineering's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Steel Supply & Engineering against Apex Systems, LLC (NV, OK, OR), a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Steel Supply & Engineering's inspection and penalty record is typical for Professional & Technical Services or an outlier against the sector's own average. View the Professional & Technical Services sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Steel Supply & Engineering safe to work at?
Based on OSHA records, Steel Supply & Engineering's workplace safety record is concerning, with multiple serious compliance issues. The employer has 7 violations across 2 inspections, including 7 serious violations. Compared to Professional & Technical Services industry peers, this is above average for penalties. Review the full inspection history below for details.
How many OSHA violations does Steel Supply & Engineering have?
Steel Supply & Engineering has 7 OSHA violations on record, including 7 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $1,775.
How many OSHA inspections has Steel Supply & Engineering had?
Steel Supply & Engineering has had 2 OSHA inspections, with the first recorded on 2015-10-29 and the most recent on 2015-12-15. This averages 3.5 violations per inspection.
What is the total penalty amount for Steel Supply & Engineering?
Steel Supply & Engineering has been assessed $1,775 in current OSHA penalties, reduced from an initial assessment of $11,050 (a 83.9% reduction).
Does Steel Supply & Engineering have any serious or willful violations?
Yes. Steel Supply & Engineering has 7 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does Steel Supply & Engineering operate in?
Steel Supply & Engineering operates in the Professional & Technical Services sector (NAICS code 541330). This industry has 3,597 employers tracked by PlainWorker, with 2,095 total OSHA inspections and $4.88M in cumulative penalties.
Where does Steel Supply & Engineering rank nationally on OSHA penalties?
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Steel Supply & Engineering ranks #78,662 (the lower half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does Steel Supply & Engineering's safety record compare to industry average?
Steel Supply & Engineering's total OSHA penalty of $1,775 is above the Professional & Technical Services industry average of $1,358 per employer (1.3x the average). The employer has 2 inspections compared to the industry average of 0.6 per employer. For a direct comparison, IMIH Group LLC in Novi, MI is a similar professional & technical services employer with $0 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 2 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.