Manufacturing · San Diego, CA
Fleet Readiness Center Southwest
According to OSHA enforcement records (2010–2026), Fleet Readiness Center Southwest has a mixed safety record: 42 violations across 14 inspections. See the full breakdown below.
- $0
- OSHA penalties
- 42
- Violations cited
- 14
- OSHA inspections
Fleet Readiness Center Southwest in San Diego, CA has been the subject of 14 OSHA workplace inspections and 42 citations since 2010, according to enforcement records from the U.S. Department of Labor. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Fleet Readiness Center Southwest 14 times over 10 years, roughly annually. These inspections resulted in 42 violations, averaging 3.0 per inspection, above what's typical for a single visit. Of these, 24 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs far above peers (5.4x the sector average) on inspection frequency. For comparison, Supreme Meats INC in Saint Francis, WI is another manufacturing employer with 2 OSHA inspections on record and $0 in current penalties.
- 3.0
- violations per inspection
- 57.1%
- of violations were serious
Compliance score
- F OSHA safety compliance: 42 violations across 14 OSHA inspections (3.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Fleet Readiness Center Southwest.
How Fleet Readiness Center Southwest Compares
Fleet Readiness Center Southwest's 3.00 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.
No OSHA penalty has been assessed against Fleet Readiness Center Southwest to date. The Manufacturing sector average runs $15,763 per employer.
Enforcement detail
OSHA Inspection History
Total Inspections
14
First Inspection
2015-01-08
Last Inspection
2024-07-10
Inspection Span
10 yrs
Violations / Inspection
3.0
Avg Penalty / Inspection
$0
Industry Avg / Inspection
$6,093
What this shows 14 inspections over 10 years, averaging 3.0 violations per visit. That's $0 per inspection vs. the Manufacturing average of $6,093.
Enforcement detail
Violation Breakdown
24
Serious
57.1% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
18
Other-Than-Serious
42.9% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Industry Safety Context: Manufacturing
How Fleet Readiness Center Southwest compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.
| Metric | Fleet Readiness Center Southwest | Industry Avg |
|---|---|---|
| Inspections | 14 | 2.6 |
| Violations | 42 | 8.0 |
| Total Penalty | $0 | $15,763 |
| Avg Penalty per Inspection | $0 | $6,093 |
Nationwide Manufacturing peers with similar penalties or inspection counts
Two OSHA-record peer sets for Fleet Readiness Center Southwest, both outside CA so the neighborhoods are not geographic containment.
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (14 inspections here).
Nearby & Similar Employers in Manufacturing
Showing 5 of 44644 other employers tracked in this sector.
Compare Fleet Readiness Center Southwest vs Chep Services, LLC side-by-side →
What to do with this record
Use Fleet Readiness Center Southwest's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Fleet Readiness Center Southwest against Chep Services, LLC, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Fleet Readiness Center Southwest's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Fleet Readiness Center Southwest safe to work at? ▼
How many OSHA violations does Fleet Readiness Center Southwest have? ▼
How many OSHA inspections has Fleet Readiness Center Southwest had? ▼
What is the total penalty amount for Fleet Readiness Center Southwest? ▼
Does Fleet Readiness Center Southwest have any serious or willful violations? ▼
What industry does Fleet Readiness Center Southwest operate in? ▼
How does Fleet Readiness Center Southwest's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.