Construction · Jessup, MD
Polytemp Corporation
According to OSHA enforcement records (2010–2026), Polytemp Corporation ranks #70,119 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 4 violations across 2 inspections.
- $2,790
- OSHA penalties
- 4
- Violations cited
- 2
- OSHA inspections
- #70,119
- of 99,447 penalized employers
Polytemp Corporation in Jessup, MD has been the subject of 2 OSHA workplace inspections and 4 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $2,790. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Polytemp Corporation 2 times over 4 years, roughly once every couple of years. These inspections resulted in 4 violations, averaging 2.0 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #70,119 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 3 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Capstone Building CORP. in Atlanta, GA is another construction employer with 2 OSHA inspections on record and $2,789 in current penalties.
- 2.0
- violations per inspection
- 75.0%
- of violations were serious
- #70,119
- of 99,447 penalized employers
Compliance score
- D OSHA safety compliance: 4 violations across 2 OSHA inspections (2.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How Polytemp Corporation compares on OSHA penalties
Total current penalty vs the Construction per-employer average
- Polytemp Corporation
Polytemp Corporation
$2,790 in penalties
- Construction avg
Construction industry average (per employer)
$6,767 in penalties
What this shows Polytemp Corporation runs moderately below peers (0.4x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$2,790 Top 29% most affordable more affordable than 71% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Polytemp Corporation.
Polytemp Corporation in the Construction enforcement ledger
Construction sector: Polytemp Corporation is the #22,267 heaviest OSHA penalty carrier of 33,222 employers with nonzero fines ($2,790).
How Polytemp Corporation Compares
Polytemp Corporation's 2.00 violations per inspection compares to the Construction sector average of 3.3 violations per employer.
Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty runs moderately below peers (0.4x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2020-06-29
Last Inspection
2024-05-07
Inspection Span
4 yrs
Violations / Inspection
2.0
Avg Penalty / Inspection
$1,395
Industry Avg / Inspection
$3,361
What this shows 2 inspections over 4 years, averaging 2.0 violations per visit. That's $1,395 per inspection vs. the Construction average of $3,361.
Enforcement detail
Violation Breakdown
3
Serious
75.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
1
Other-Than-Serious
25.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$8,725
Current Penalty Amount
$2,790
Penalty Reduction
68.0%
What this shows Penalties were reduced by $5,935 from the initial assessment of $8,725. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Construction
How Polytemp Corporation compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.
| Metric | Polytemp Corporation | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.0 |
| Violations | 4 | 3.3 |
| Total Penalty | $2,790 | $6,767 |
| Avg Penalty per Inspection | $1,395 | $3,361 |
Nationwide Construction peers with similar penalties or inspection counts
Two OSHA-record peer sets for Polytemp Corporation, both outside MD so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($2,790 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Construction
Showing 5 of 61259 other employers tracked in this sector.
Compare Polytemp Corporation vs Capstone Building CORP. side-by-side →
What to do with this record
Use Polytemp Corporation's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Polytemp Corporation against Capstone Building CORP., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Polytemp Corporation's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Polytemp Corporation safe to work at? ▼
How many OSHA violations does Polytemp Corporation have? ▼
How many OSHA inspections has Polytemp Corporation had? ▼
What is the total penalty amount for Polytemp Corporation? ▼
Does Polytemp Corporation have any serious or willful violations? ▼
What industry does Polytemp Corporation operate in? ▼
Where does Polytemp Corporation rank nationally on OSHA penalties? ▼
How does Polytemp Corporation's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.