Manufacturing · Columbus, OH

International Technical Coatings, INC.

According to OSHA enforcement records (2010–2026), International Technical Coatings, INC. ranks #385 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 41 violations across 11 inspections.

Top 1% by penalty71% serious
$243,565
OSHA penalties
41
Violations cited
11
OSHA inspections
#385
of 99,447 penalized employers

International Technical Coatings, INC. in Columbus, OH has been the subject of 11 OSHA workplace inspections and 41 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $243,565. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected International Technical Coatings, INC. 11 times over 7 years, roughly annually. These inspections resulted in 41 violations, averaging 3.7 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #385 of 99,447 penalized U.S. employers (the top 1% of penalized employers nationally). Of these, 29 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs well above peers (4.3x the sector average) on inspection frequency. For comparison, Krispy Kreme Doughnut Corporation in West Allis, WI is another manufacturing employer with 2 OSHA inspections on record and $244,078 in current penalties.

3.7
violations per inspection
70.7%
of violations were serious
#385
of 99,447 penalized employers

Compliance score

F 36/100
  • F OSHA safety compliance: 41 violations across 11 OSHA inspections (3.7 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How this employer compares on OSHA penalties

Total current penalty vs the Manufacturing per-employer average

in penalties

What this shows International Technical Coatings, INC. runs far above peers (15.5x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$243,565 Bottom 1% least affordable more affordable than 0% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). Below this entry. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Below this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Below this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Below this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Below this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Below this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Below this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Below this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Below this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Below this entry. $50,000+: 5,150 U.S. employers with a penalty (5%). This entry ($243,565) is well above this band, the chart's rightmost open-ended bucket. This employer: $243,565 $0 $55,000+ every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is International Technical Coatings, INC..

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both10.911.01111.011.15.419.73448.362.6OSHA inspectionsViolations citedTABLE TALK PIES, INC., OSHA inspections: 11 · Violations cited: 19ALL-FEED PROCESSING …, OSHA inspections: 11 · Violations cited: 42ELITE SPICE INC., OSHA inspections: 11 · Violations cited: 24FAIRHAVEN SHIPYARD, OSHA inspections: 11 · Violations cited: 8PERFORMANCE PALLET C…, OSHA inspections: 11 · Violations cited: 39CAESARSTONE TECHNOLO…, OSHA inspections: 11 · Violations cited: 26BLUEBIRD ENTERPRISES…, OSHA inspections: 11 · Violations cited: 60NORTHEAST INDUSTRIAL…, OSHA inspections: 11 · Violations cited: 44PELLA CORPORATION, OSHA inspections: 11 · Violations cited: 11PHOENIX PACKAGING OP…, OSHA inspections: 11 · Violations cited: 33SIERRA PACIFIC INDUS…, OSHA inspections: 11 · Violations cited: 13DRAKE ENTERPRISES INC, OSHA inspections: 11 · Violations cited: 14AGRI STAR MEAT AND P…, OSHA inspections: 11 · Violations cited: 40PHILLIPS 66, OSHA inspections: 11 · Violations cited: 10BIRDSBORO KOSHER FAR…, OSHA inspections: 11 · Violations cited: 54NATIONAL BEEF PACKIN…, OSHA inspections: 11 · Violations cited: 37MOUNT FRANKLIN FOODS…, OSHA inspections: 11 · Violations cited: 25NATURE'S PATH USA II…, OSHA inspections: 11 · Violations cited: 32TRUE TEMPER SPORTS, …, OSHA inspections: 11 · Violations cited: 18TROJAN BATTERY COMPA…, OSHA inspections: 11 · Violations cited: 15International Techni…, OSHA inspections: 11 · Violations cited: 41
International Technical Coatings, INC. has 11 OSHA inspections on record and 41 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

International Technical Coatings, INC. in the Manufacturing enforcement ledger

Among 35,243 Manufacturing employers with OSHA penalties on file, International Technical Coatings, INC. ranks #221 at $243,565 current penalty.

How International Technical Coatings, INC. Compares

International Technical Coatings, INC.'s 3.73 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs far above peers (15.5x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

11

First Inspection

2016-12-12

Last Inspection

2024-02-08

Inspection Span

7 yrs

Violations / Inspection

3.7

Avg Penalty / Inspection

$22,142

Industry Avg / Inspection

$6,093

What this shows 11 inspections over 7 years, averaging 3.7 violations per visit. That's $22,142 per inspection vs. the Manufacturing average of $6,093.

Enforcement detail

Violation Breakdown

29

Serious

70.7% of total

0

Willful

0.0% of total

12

Repeat

29.3% of total

0

Other-Than-Serious

0.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$660,913

Current Penalty Amount

$243,565

Penalty Reduction

63.1%

What this shows Penalties were reduced by $417,348 from the initial assessment of $660,913. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How International Technical Coatings, INC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric International Technical Coatings, INC. Industry Avg
Inspections 11 2.6
Violations 41 8.0
Total Penalty $243,565 $15,763
Avg Penalty per Inspection $22,142 $6,093

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for International Technical Coatings, INC., both outside OH so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($243,565 here).

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (11 inspections here).

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Compare International Technical Coatings, INC. vs STX Beef Company, LLC side-by-side →

What to do with this record

Use International Technical Coatings, INC.'s enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare International Technical Coatings, INC. against STX Beef Company, LLC, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether International Technical Coatings, INC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is International Technical Coatings, INC. safe to work at?
Based on OSHA records, International Technical Coatings, INC.'s workplace safety record is concerning, with multiple serious compliance issues. The employer has 41 violations across 11 inspections, including 29 serious violations. Compared to Manufacturing industry peers, this is above average for penalties. Review the full inspection history below for details.
How many OSHA violations does International Technical Coatings, INC. have?
International Technical Coatings, INC. has 41 OSHA violations on record, including 29 serious, 0 willful, and 12 repeat violations. The total current penalty amount is $243,565.
How many OSHA inspections has International Technical Coatings, INC. had?
International Technical Coatings, INC. has had 11 OSHA inspections, with the first recorded on 2016-12-12 and the most recent on 2024-02-08. This averages 3.7 violations per inspection.
What is the total penalty amount for International Technical Coatings, INC.?
International Technical Coatings, INC. has been assessed $243,565 in current OSHA penalties, reduced from an initial assessment of $660,913 (a 63.1% reduction).
Does International Technical Coatings, INC. have any serious or willful violations?
Yes. International Technical Coatings, INC. has 29 serious violations, and 12 repeat violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does International Technical Coatings, INC. operate in?
International Technical Coatings, INC. operates in the Manufacturing sector (NAICS code 332618). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.
Where does International Technical Coatings, INC. rank nationally on OSHA penalties?
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, International Technical Coatings, INC. ranks #385 (the top 1% of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does International Technical Coatings, INC.'s safety record compare to industry average?
International Technical Coatings, INC.'s total OSHA penalty of $243,565 is above the Manufacturing industry average of $15,763 per employer (15.5x the average). The employer has 11 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Krispy Kreme Doughnut Corporation in West Allis, WI is a similar manufacturing employer with $244,078 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 11 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.