PlainWorker
Employers › VA

Manufacturing · Norfolk, VA

General Dynamics Information Technology

According to OSHA enforcement records (2010–2026), General Dynamics Information Technology ranks #41,012 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 3 violations across 3 inspections.

Upper half by penalty67% serious
$8,105
OSHA penalties
3
Violations cited
3
OSHA inspections
#41,012
of 99,447 penalized employers

General Dynamics Information Technology in Norfolk, VA has been the subject of 3 OSHA workplace inspections and 3 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $8,105. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected General Dynamics Information Technology 3 times over 1 year - more than twice a year on average. These inspections resulted in 3 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #41,012 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this sits roughly in line with peers (1.2x the sector average) on inspection frequency. For comparison, Smyrna Ready Mix Concrete, LLC in Nashville, TN is another manufacturing employer with 2 OSHA inspections on record and $8,105 in current penalties.

1.0
violations per inspection
66.7%
of violations were serious
#41,012
of 99,447 penalized employers

Compliance score

C 75/100
  • C OSHA safety compliance: 3 violations across 3 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How this employer compares on OSHA penalties

Total current penalty vs the Manufacturing per-employer average

in penalties

What this shows General Dynamics Information Technology runs moderately below peers (0.5x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$8,105 Bottom 41% least affordable more affordable than 41% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). Below this entry. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). This entry sits in this band. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Above this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is General Dynamics Information Technology.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both3.03.033.03.00.110.52131.441.9OSHA inspectionsViolations citedDAKOTA BODIES, LLC, OSHA inspections: 3 · Violations cited: 30LE PAFE, INC., OSHA inspections: 3 · Violations cited: 17TFP CORPORATION, OSHA inspections: 3 · Violations cited: 28EQUISTAR CHEMICALS, LP, OSHA inspections: 3 · Violations cited: 6BIZON GROUP INC., OSHA inspections: 3 · Violations cited: 25UNITED WINDOW & DOOR…, OSHA inspections: 3 · Violations cited: 12SOUTHERN MINNESOTA B…, OSHA inspections: 3 · Violations cited: 13KARAVAN TRAILERS, INC., OSHA inspections: 3 · Violations cited: 7J.B. STAMPING INC., OSHA inspections: 3 · Violations cited: 29EXPERA SPECIALTY SOL…, OSHA inspections: 3 · Violations cited: 9EVERSON TESLA, INC., OSHA inspections: 3 · Violations cited: 28AMERICAN BUILDING SU…, OSHA inspections: 3 · Violations cited: 33SOUTHERN STATES COOP…, OSHA inspections: 3 · Violations cited: 12NEWMAN TECHNOLOGY SO…, OSHA inspections: 3 · Violations cited: 40AMERICAN ACRYLIC & I…, OSHA inspections: 3 · Violations cited: 11JIM C. HAMER COMPANY, OSHA inspections: 3 · Violations cited: 2MERRILL INDUSTRIES, …, OSHA inspections: 3 · Violations cited: 15EATON CORPORATION, OSHA inspections: 3 · Violations cited: 9COINCO, INC., OSHA inspections: 3 · Violations cited: 15GUNBOAT INTERNATIONA…, OSHA inspections: 3 · Violations cited: 13General Dynamics Inf…, OSHA inspections: 3 · Violations cited: 3
General Dynamics Information Technology has 3 OSHA inspections on record and 3 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

General Dynamics Information Technology in the Manufacturing enforcement ledger

In Manufacturing, General Dynamics Information Technology sits at penalty rank #18,088 of 35,243 penalized establishments ($8,105 assessed).

How General Dynamics Information Technology Compares

General Dynamics Information Technology's 1.00 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately below peers (0.5x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

3

First Inspection

2022-08-16

Last Inspection

2023-11-07

Inspection Span

1 yr

Violations / Inspection

1.0

Avg Penalty / Inspection

$2,702

Industry Avg / Inspection

$6,093

What this shows 3 inspections over 1 year, averaging 1.0 violations per visit. That's $2,702 per inspection vs. the Manufacturing average of $6,093.

Enforcement detail

Violation Breakdown

2

Serious

66.7% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

1

Other-Than-Serious

33.3% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$23,985

Current Penalty Amount

$8,105

Penalty Reduction

66.2%

What this shows Penalties were reduced by $15,880 from the initial assessment of $23,985. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How General Dynamics Information Technology compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric General Dynamics Information Technology Industry Avg
Inspections 3 2.6
Violations 3 8.0
Total Penalty $8,105 $15,763
Avg Penalty per Inspection $2,702 $6,093
View all 44,645 employers in Manufacturing →

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for General Dynamics Information Technology, both outside VA so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($8,105 here).

Smyrna Ready Mix Concrete, LLC $8,105 TN American Stave Company $8,106 OH Independent's Service Company $8,106 MO Kanawha Manufacturing Company $8,107 WV

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (3 inspections here).

Dakota Bodies, LLC 3 insp. Watertown, SD Le Pafe, INC. 3 insp. Montebello, CA TFP Corporation 3 insp. Medina, OH Equistar Chemicals, LP 3 insp. Tuscola, IL

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Smyrna Ready Mix Concrete, LLC
Nashville, TN
2 inspections $8,105
American Stave Company
Zanesville, OH
2 inspections $8,106
Independent's Service Company
Hannibal, MO
2 inspections $8,106
Kanawha Manufacturing Company
Charleston, WV
3 inspections $8,107
Erg Aerospace Corporation
Sparks, NV
3 inspections $8,101

Compare General Dynamics Information Technology vs Smyrna Ready Mix Concrete, LLC side-by-side →

What to do with this record

Use General Dynamics Information Technology's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare General Dynamics Information Technology against Smyrna Ready Mix Concrete, LLC, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether General Dynamics Information Technology's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is General Dynamics Information Technology safe to work at? ▼
Based on OSHA records, General Dynamics Information Technology's workplace safety record is relatively clean, with fewer violations than typical. The employer has 3 violations across 3 inspections, including 2 serious violations. Compared to Manufacturing industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does General Dynamics Information Technology have? ▼
General Dynamics Information Technology has 3 OSHA violations on record, including 2 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $8,105.
How many OSHA inspections has General Dynamics Information Technology had? ▼
General Dynamics Information Technology has had 3 OSHA inspections, with the first recorded on 2022-08-16 and the most recent on 2023-11-07. This averages 1.0 violations per inspection.
What is the total penalty amount for General Dynamics Information Technology? ▼
General Dynamics Information Technology has been assessed $8,105 in current OSHA penalties, reduced from an initial assessment of $23,985 (a 66.2% reduction).
Does General Dynamics Information Technology have any serious or willful violations? ▼
Yes. General Dynamics Information Technology has 2 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does General Dynamics Information Technology operate in? ▼
General Dynamics Information Technology operates in the Manufacturing sector (NAICS code 336611). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.
Where does General Dynamics Information Technology rank nationally on OSHA penalties? ▼
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, General Dynamics Information Technology ranks #41,012 (the upper half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does General Dynamics Information Technology's safety record compare to industry average? ▼
General Dynamics Information Technology's total OSHA penalty of $8,105 is below the Manufacturing industry average of $15,763 per employer. The employer has 3 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Smyrna Ready Mix Concrete, LLC in Nashville, TN is a similar manufacturing employer with $8,105 in current penalties.
Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 3 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.