Construction · Sumter, SC

G & S Metal Building INC

According to OSHA enforcement records (2010–2026), G & S Metal Building INC ranks #77,273 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 4 violations across 2 inspections.

Lower half by penalty100% serious
$1,939
OSHA penalties
4
Violations cited
2
OSHA inspections
#77,273
of 99,447 penalized employers

G & S Metal Building INC in Sumter, SC has been the subject of 2 OSHA workplace inspections and 4 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $1,939. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected G & S Metal Building INC 2 times over 1 year - more than twice a year on average. These inspections resulted in 4 violations, averaging 2.0 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #77,273 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 4 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Freddy's Remodeling & Roofing LLC in Richmond, VA is another construction employer with 2 OSHA inspections on record and $1,940 in current penalties.

2.0
violations per inspection
100.0%
of violations were serious
#77,273
of 99,447 penalized employers

Compliance score

D 61/100
  • D OSHA safety compliance: 4 violations across 2 OSHA inspections (2.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How G & S Metal Building INC compares on OSHA penalties

Total current penalty vs the Construction per-employer average

in penalties

What this shows G & S Metal Building INC runs well below peers (0.29x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$1,939 Top 22% most affordable more affordable than 78% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). This entry sits in this band. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Above this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Above this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is G & S Metal Building INC.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both1.92.022.02.01.25.61014.418.8OSHA inspectionsViolations citedLEE CONTRACTING, INC., OSHA inspections: 2 · Violations cited: 7RITCHIE-CURBOW CONST…, OSHA inspections: 2 · Violations cited: 12PARKWAY ELEVATORS, I…, OSHA inspections: 2 · Violations cited: 12BUILD LOVE, OSHA inspections: 2 · Violations cited: 18PHILLIPS HOME IMPROV…, OSHA inspections: 2 · Violations cited: 7AERIAL PRECAST CONCR…, OSHA inspections: 2 · Violations cited: 2GARCIA FRAMING LLC, OSHA inspections: 2 · Violations cited: 7TOWNSHIP OF MOORESTO…, OSHA inspections: 2 · Violations cited: 9TEXANA BUILDERS, OSHA inspections: 2 · Violations cited: 3PARAMOUNT CONSTRUCTI…, OSHA inspections: 2 · Violations cited: 5CRAMER AND ASSOCIATES, OSHA inspections: 2 · Violations cited: 5CHUPP CONSTRUCTION LLC, OSHA inspections: 2 · Violations cited: 11WARREN EXTERIORS LLC, OSHA inspections: 2 · Violations cited: 7GREEN SPRINGS BUILDERS, OSHA inspections: 2 · Violations cited: 6MARK KYROUAC DBA MAR…, OSHA inspections: 2 · Violations cited: 6RENE FLORES, OSHA inspections: 2 · Violations cited: 10PULVER ROOFING, INC, OSHA inspections: 2 · Violations cited: 10EVERGREEN BUILDERS O…, OSHA inspections: 2 · Violations cited: 4ALVAREZ CONSTRUCTION…, OSHA inspections: 2 · Violations cited: 2PNG CONSTRUCTION, LLC, OSHA inspections: 2 · Violations cited: 8G & S Metal Building…, OSHA inspections: 2 · Violations cited: 4
G & S Metal Building INC has 2 OSHA inspections on record and 4 violations cited. The crosshair marks the median among these Construction peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

G & S Metal Building INC in the Construction enforcement ledger

Construction sector: G & S Metal Building INC is the #25,058 heaviest OSHA penalty carrier of 33,222 employers with nonzero fines ($1,939).

How G & S Metal Building INC Compares

G & S Metal Building INC's 2.00 violations per inspection compares to the Construction sector average of 3.3 violations per employer.

Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty runs well below peers (0.29x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

2

First Inspection

2011-07-27

Last Inspection

2012-01-20

Inspection Span

1 yr

Violations / Inspection

2.0

Avg Penalty / Inspection

$970

Industry Avg / Inspection

$3,361

What this shows 2 inspections over 1 year, averaging 2.0 violations per visit. That's $970 per inspection vs. the Construction average of $3,361.

Enforcement detail

Violation Breakdown

4

Serious

100.0% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

0

Other-Than-Serious

0.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$3,875

Current Penalty Amount

$1,939

Penalty Reduction

50.0%

What this shows Penalties were reduced by $1,936 from the initial assessment of $3,875. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Construction

How G & S Metal Building INC compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.

Metric G & S Metal Building INC Industry Avg
Inspections 2 2.0
Violations 4 3.3
Total Penalty $1,939 $6,767
Avg Penalty per Inspection $970 $3,361

Nationwide Construction peers with similar penalties or inspection counts

Two OSHA-record peer sets for G & S Metal Building INC, both outside SC so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($1,939 here).

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Nearby & Similar Employers in Construction

Showing 5 of 61259 other employers tracked in this sector.

Compare G & S Metal Building INC vs The Plumber / 72 degrees side-by-side →

What to do with this record

Use G & S Metal Building INC's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare G & S Metal Building INC against The Plumber / 72 degrees, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether G & S Metal Building INC's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is G & S Metal Building INC safe to work at?
Based on OSHA records, G & S Metal Building INC's workplace safety record is mixed, with some compliance concerns. The employer has 4 violations across 2 inspections, including 4 serious violations. Compared to Construction industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does G & S Metal Building INC have?
G & S Metal Building INC has 4 OSHA violations on record, including 4 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $1,939.
How many OSHA inspections has G & S Metal Building INC had?
G & S Metal Building INC has had 2 OSHA inspections, with the first recorded on 2011-07-27 and the most recent on 2012-01-20. This averages 2.0 violations per inspection.
What is the total penalty amount for G & S Metal Building INC?
G & S Metal Building INC has been assessed $1,939 in current OSHA penalties, reduced from an initial assessment of $3,875 (a 50.0% reduction).
Does G & S Metal Building INC have any serious or willful violations?
Yes. G & S Metal Building INC has 4 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does G & S Metal Building INC operate in?
G & S Metal Building INC operates in the Construction sector (NAICS code 238190). This industry has 61,260 employers tracked by PlainWorker, with 123,354 total OSHA inspections and $414.57M in cumulative penalties.
Where does G & S Metal Building INC rank nationally on OSHA penalties?
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, G & S Metal Building INC ranks #77,273 (the lower half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does G & S Metal Building INC's safety record compare to industry average?
G & S Metal Building INC's total OSHA penalty of $1,939 is below the Construction industry average of $6,767 per employer. The employer has 2 inspections compared to the industry average of 2.0 per employer. For a direct comparison, Freddy's Remodeling & Roofing LLC in Richmond, VA is a similar construction employer with $1,940 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 2 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.