Manufacturing · Golconda, NV

Diamond Plastics Corporation

According to OSHA enforcement records (2010–2026), Diamond Plastics Corporation ranks #4,569 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 45 violations across 7 inspections.

Top 5% by penalty56% serious

Compiled by Plainworker · September 6, 2026

$54,170
OSHA penalties: 45
Violations cited: 7
OSHA inspections: #4,569
of 99,447 penalized employers

Diamond Plastics Corporation in Golconda, NV has been the subject of 7 OSHA workplace inspections and 45 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $54,170. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Diamond Plastics Corporation 7 times across a longer 16-year span, an infrequent cadence. These inspections resulted in 45 violations, averaging 6.4 per inspection - a notably high rate. According to OSHA enforcement records, its total current penalty ranks #4,569 of 99,447 penalized U.S. employers (the top 5% of penalized employers nationally). Of these, 25 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs well above peers (2.7x the sector average) on inspection frequency. For comparison, CJ Foods Manufacturing Beaumont CORP. in Beaumont, CA is another manufacturing employer with 3 OSHA inspections on record and $54,165 in current penalties.

6.4
violations per inspection: 55.6%
of violations were serious: #4,569
of 99,447 penalized employers

Compliance score

F 0/100

F OSHA safety compliance: 45 violations across 7 OSHA inspections (6.4 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Diamond Plastics Corpo…

$54,170
Manufacturing avg

$15,763

What this shows Diamond Plastics Corporation runs well above peers (3.4x the sector average) in total OSHA penalties.

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$54,170 Bottom 5% least affordable more affordable than 5% of 99,447 U.S. employers with a penalty

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Diamond Plastics Corporation.

Diamond Plastics Corporation has 7 OSHA inspections on record and 45 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Diamond Plastics Corporation in the Manufacturing enforcement ledger

In Manufacturing, Diamond Plastics Corporation sits at penalty rank #2,330 of 35,243 penalized establishments ($54,170 assessed).

How Diamond Plastics Corporation Compares

Diamond Plastics Corporation's 6.43 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs well above peers (3.4x the sector average).

Total Inspections

First Inspection

2010-04-20

Last Inspection

2026-03-16

Inspection Span

16 yrs

Violations / Inspection

6.4

Avg Penalty / Inspection

$7,739

Industry Avg / Inspection

$6,093

What this shows 7 inspections over 16 years, averaging 6.4 violations per visit. That's $7,739 per inspection vs. the Manufacturing average of $6,093.

Serious

55.6% of total

Willful

0.0% of total

Repeat

0.0% of total

Other-Than-Serious

44.4% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Initial Penalty Assessed

$94,486

Current Penalty Amount

$54,170

Penalty Reduction

42.7%

What this shows Penalties were reduced by $40,316 from the initial assessment of $94,486. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How Diamond Plastics Corporation compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric	Diamond Plastics Corporation	Industry Avg
Inspections	7	2.6
Violations	45	8.0
Total Penalty	$54,170	$15,763
Avg Penalty per Inspection	$7,739	$6,093

View all 44,645 employers in Manufacturing →

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for Diamond Plastics Corporation, both outside NV so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($54,170 here).

North American Stainless $54,175 KY CJ Foods Manufacturing Beaumont CORP. $54,165 CA Hometown Foods USA INC and S-Innovations CORP $54,152 FL West Fraser Wood Products, INC. $54,137 TX

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (7 inspections here).

Outdoor Furniture Refinishing, INC. 7 insp. Houston, TX Pga Incorporated 7 insp. Freeland, PA Trailer Component Manufacturing, INC. (Tracom) 7 insp. Mentor, OH Owens Corning Insulating Systems, LLC 7 insp. Feura Bush, NY

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

North American Stainless

Ghent, KY

7 inspections $54,175

CJ Foods Manufacturing Beaumont CORP.

Beaumont, CA

3 inspections $54,165

Teijin Automotive Technologies

North Baltimore, OH

3 inspections $0

Hometown Foods USA INC and S-Innovations CORP

Medley, FL

5 inspections $54,152

West Fraser Wood Products, INC.

Henderson, TX

2 inspections $54,137

Compare Diamond Plastics Corporation vs North American Stainless side-by-side →

What to do with this record

Use Diamond Plastics Corporation's enforcement history as one data point, not the whole picture.

A single employer's record can look unusual in isolation. Compare Diamond Plastics Corporation against North American Stainless, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
See whether Diamond Plastics Corporation's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Diamond Plastics Corporation safe to work at? ▼

Based on OSHA records, Diamond Plastics Corporation's workplace safety record is concerning, with multiple serious compliance issues. The employer has 45 violations across 7 inspections, including 25 serious violations. Compared to Manufacturing industry peers, this is above average for penalties. Review the full inspection history below for details.

How many OSHA violations does Diamond Plastics Corporation have? ▼

Diamond Plastics Corporation has 45 OSHA violations on record, including 25 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $54,170.

How many OSHA inspections has Diamond Plastics Corporation had? ▼

Diamond Plastics Corporation has had 7 OSHA inspections, with the first recorded on 2010-04-20 and the most recent on 2026-03-16. This averages 6.4 violations per inspection.

What is the total penalty amount for Diamond Plastics Corporation? ▼

Diamond Plastics Corporation has been assessed $54,170 in current OSHA penalties, reduced from an initial assessment of $94,486 (a 42.7% reduction).

Does Diamond Plastics Corporation have any serious or willful violations? ▼

Yes. Diamond Plastics Corporation has 25 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.

What industry does Diamond Plastics Corporation operate in? ▼

Diamond Plastics Corporation operates in the Manufacturing sector (NAICS code 326122). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.

Where does Diamond Plastics Corporation rank nationally on OSHA penalties? ▼

Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Diamond Plastics Corporation ranks #4,569 (the top 5% of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.

How does Diamond Plastics Corporation's safety record compare to industry average? ▼

Diamond Plastics Corporation's total OSHA penalty of $54,170 is above the Manufacturing industry average of $15,763 per employer (3.4x the average). The employer has 7 inspections compared to the industry average of 2.6 per employer. For a direct comparison, CJ Foods Manufacturing Beaumont CORP. in Beaumont, CA is a similar manufacturing employer with $54,165 in current penalties.

Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.