Wholesale Trade · Solon, OH

Core Mark International

According to OSHA enforcement records (2010–2026), Core Mark International has a relatively clean safety record: 0 violations across 2 inspections. See the full breakdown below.

$0
OSHA penalties
0
Violations cited
2
OSHA inspections

Core Mark International in Solon, OH has been the subject of 2 OSHA workplace inspections and 0 citations since 2010, according to enforcement records from the U.S. Department of Labor. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Core Mark International 2 times over 4 years, roughly once every couple of years. None of these inspections resulted in a citation. Against the Wholesale Trade industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Sam's Food Distributor in ST Croix, VI is another wholesale trade employer with 2 OSHA inspections on record and $0 in current penalties.

0.0
violations per inspection
0.0%
of violations were serious

Compliance score

A 90/100
  • A OSHA safety compliance: 0 violations across 2 OSHA inspections (0.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Wholesale Trade employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Core Mark International.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both1.92.022.02.007.615.222.830.4OSHA inspectionsViolations citedCHS, INC., OSHA inspections: 2 · Violations cited: 17METALICO BUFFALO, INC., OSHA inspections: 2 · Violations cited: 6LUNDAY-THAGARD COMPANY, OSHA inspections: 2 · Violations cited: 26ALRO STEEL CORPORATION, OSHA inspections: 2 · Violations cited: 14RAMAR INTERNATIONAL …, OSHA inspections: 2 · Violations cited: 11IRSIK & DOLL FEED SE…, OSHA inspections: 2 · Violations cited: 7SUPPLY SOURCE ENTERP…, OSHA inspections: 2 · Violations cited: 10NESTLE DREYER'S ICE …, OSHA inspections: 2 · Violations cited: 2LA FURNITURE WAREHOU…, OSHA inspections: 2 · Violations cited: 5US PIPE FABRICATION,…, OSHA inspections: 2 · Violations cited: 6W T HARVEY LUMBER CO…, OSHA inspections: 2 · Violations cited: 3BRENNTAG PACIFIC INC., OSHA inspections: 2 · Violations cited: 4DEB EL FOODS, OSHA inspections: 2 · Violations cited: 3SAWMILL HYDRAULICS I…, OSHA inspections: 2 · Violations cited: 10FURNITURE LIQUIDATOR…, OSHA inspections: 2 · Violations cited: 29VIDALIA AUTO SALVAGE…, OSHA inspections: 2 · Violations cited: 12GPS METALS, INC., OSHA inspections: 2 · Violations cited: 9YELL-O-GLOW CORPORAT…, OSHA inspections: 2 · Violations cited: 3INDUSTRIAL RESIN REC…, OSHA inspections: 2 · Violations cited: 9PINNACLE PROPANE EXP…, OSHA inspections: 2 · Violations cited: 4Core Mark Internatio…, OSHA inspections: 2 · Violations cited: 0
Core Mark International has 2 OSHA inspections on record and 0 violations cited. The crosshair marks the median among these Wholesale Trade peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

How Core Mark International Compares

2 OSHA inspections on record for Core Mark International in Solon, OH, zero violations cited, a cleaner record than the Wholesale Trade sector average of 5.5 violations per employer.

No OSHA penalty has been assessed against Core Mark International to date. The Wholesale Trade sector average runs $9,112 per employer.

Enforcement detail

OSHA Inspection History

Total Inspections

2

First Inspection

2020-02-04

Last Inspection

2024-07-24

Inspection Span

4 yrs

Violations / Inspection

0.0

Avg Penalty / Inspection

$0

Industry Avg / Inspection

$4,665

What this shows 2 inspections over 4 years, averaging 0.0 violations per visit. That's $0 per inspection vs. the Wholesale Trade average of $4,665.

Industry Safety Context: Wholesale Trade

How Core Mark International compares to the Wholesale Trade sector, which has 6,881 employers tracked by PlainWorker.

Metric Core Mark International Industry Avg
Inspections 2 2.0
Violations 0 5.5
Total Penalty $0 $9,112
Avg Penalty per Inspection $0 $4,665

Nationwide Wholesale Trade peers with similar penalties or inspection counts

Two OSHA-record peer sets for Core Mark International, both outside OH so the neighborhoods are not geographic containment.

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Nearby & Similar Employers in Wholesale Trade

Showing 5 of 6880 other employers tracked in this sector.

Compare Core Mark International vs Mid Columbia Forklift INC side-by-side →

What to do with this record

Use Core Mark International's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Core Mark International against Mid Columbia Forklift INC, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Core Mark International's inspection and penalty record is typical for Wholesale Trade or an outlier against the sector's own average. View the Wholesale Trade sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Core Mark International safe to work at?
Based on OSHA records, Core Mark International's workplace safety record is relatively clean, with fewer violations than typical. The employer has 0 violations across 2 inspections. Compared to Wholesale Trade industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does Core Mark International have?
Core Mark International has 0 OSHA violations on record, including 0 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $0.
How many OSHA inspections has Core Mark International had?
Core Mark International has had 2 OSHA inspections, with the first recorded on 2020-02-04 and the most recent on 2024-07-24. This averages 0.0 violations per inspection.
What is the total penalty amount for Core Mark International?
Core Mark International has been assessed $0 in current OSHA penalties.
What industry does Core Mark International operate in?
Core Mark International operates in the Wholesale Trade sector (NAICS code 424410). This industry has 6,881 employers tracked by PlainWorker, with 13,442 total OSHA inspections and $62.70M in cumulative penalties.
How does Core Mark International's safety record compare to industry average?
Core Mark International's total OSHA penalty of $0 is below the Wholesale Trade industry average of $9,112 per employer. The employer has 2 inspections compared to the industry average of 2.0 per employer. For a direct comparison, Sam's Food Distributor in ST Croix, VI is a similar wholesale trade employer with $0 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 2 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.