Manufacturing · Baton Rouge, LA

Cam Motion, INC.

According to OSHA enforcement records (2010–2026), Cam Motion, INC. ranks #51,409 of 99,447 penalized U.S. employers by total current penalty, with a average safety record: 3 violations across 2 inspections.

Lower half by penalty67% serious

Compiled by Plainworker · September 6, 2026

$5,724
OSHA penalties: 3
Violations cited: 2
OSHA inspections: #51,409
of 99,447 penalized employers

Cam Motion, INC. in Baton Rouge, LA has been the subject of 2 OSHA workplace inspections and 3 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $5,724. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Cam Motion, INC. 2 times over 4 years, roughly once every couple of years. These inspections resulted in 3 violations, averaging 1.5 per inspection. According to OSHA enforcement records, its total current penalty ranks #51,409 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately below peers (0.8x the sector average) on inspection frequency. For comparison, Marktec INC. in Dalton, GA is another manufacturing employer with 3 OSHA inspections on record and $5,722 in current penalties.

1.5
violations per inspection: 66.7%
of violations were serious: #51,409
of 99,447 penalized employers

Compliance score

C 68/100

C OSHA safety compliance: 3 violations across 2 OSHA inspections (1.5 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Cam Motion, INC.

$5,724
Manufacturing avg

$15,763

What this shows Cam Motion, INC. runs moderately below peers (0.4x the sector average) in total OSHA penalties.

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$5,724 Top 48% most affordable more affordable than 52% of 99,447 U.S. employers with a penalty

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Cam Motion, INC..

Cam Motion, INC. has 2 OSHA inspections on record and 3 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Cam Motion, INC. in the Manufacturing enforcement ledger

In Manufacturing, Cam Motion, INC. sits at penalty rank #21,784 of 35,243 penalized establishments ($5,724 assessed).

How Cam Motion, INC. Compares

Cam Motion, INC.'s 1.50 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately below peers (0.4x the sector average).

Total Inspections

First Inspection

2018-10-22

Last Inspection

2022-11-09

Inspection Span

4 yrs

Violations / Inspection

1.5

Avg Penalty / Inspection

$2,862

Industry Avg / Inspection

$6,093

What this shows 2 inspections over 4 years, averaging 1.5 violations per visit. That's $2,862 per inspection vs. the Manufacturing average of $6,093.

Serious

66.7% of total

Willful

0.0% of total

Repeat

0.0% of total

Other-Than-Serious

33.3% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Initial Penalty Assessed

$6,611

Current Penalty Amount

$5,724

Penalty Reduction

13.4%

What this shows Penalties were reduced by $887 from the initial assessment of $6,611. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How Cam Motion, INC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric	Cam Motion, INC.	Industry Avg
Inspections	2	2.6
Violations	3	8.0
Total Penalty	$5,724	$15,763
Avg Penalty per Inspection	$2,862	$6,093

View all 44,645 employers in Manufacturing →

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for Cam Motion, INC., both outside LA so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($5,724 here).

Brooks Industrial Coating $5,722 TX Marktec INC. $5,722 GA Island Marine, LLC $5,727 AK American Avk Company $5,727 NV

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Newman & Company 2 insp. Philadelphia, PA Whitesell Corporation 2 insp. Muscle Shoals, AL Fabco LLC 2 insp. Denver, CO Pallets and More LLC 2 insp. Zebulon, GA

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Burnette Foods

New Era, MI

1 inspections $0

Brooks Industrial Coating

Compare Cam Motion, INC. vs Burnette Foods side-by-side →

What to do with this record

Use Cam Motion, INC.'s enforcement history as one data point, not the whole picture.

A single employer's record can look unusual in isolation. Compare Cam Motion, INC. against Burnette Foods, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
See whether Cam Motion, INC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Cam Motion, INC. safe to work at? ▼

Based on OSHA records, Cam Motion, INC.'s workplace safety record is average, with typical for this industry. The employer has 3 violations across 2 inspections, including 2 serious violations. Compared to Manufacturing industry peers, this is below average for penalties. Review the full inspection history below for details.

How many OSHA violations does Cam Motion, INC. have? ▼

Cam Motion, INC. has 3 OSHA violations on record, including 2 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $5,724.

How many OSHA inspections has Cam Motion, INC. had? ▼

Cam Motion, INC. has had 2 OSHA inspections, with the first recorded on 2018-10-22 and the most recent on 2022-11-09. This averages 1.5 violations per inspection.

What is the total penalty amount for Cam Motion, INC.? ▼

Cam Motion, INC. has been assessed $5,724 in current OSHA penalties, reduced from an initial assessment of $6,611 (a 13.4% reduction).

Does Cam Motion, INC. have any serious or willful violations? ▼

Yes. Cam Motion, INC. has 2 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.

What industry does Cam Motion, INC. operate in? ▼

Cam Motion, INC. operates in the Manufacturing sector (NAICS code 332312). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.

Where does Cam Motion, INC. rank nationally on OSHA penalties? ▼

Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Cam Motion, INC. ranks #51,409 (the lower half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.

How does Cam Motion, INC.'s safety record compare to industry average? ▼

Cam Motion, INC.'s total OSHA penalty of $5,724 is below the Manufacturing industry average of $15,763 per employer. The employer has 2 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Marktec INC. in Dalton, GA is a similar manufacturing employer with $5,722 in current penalties.

Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.