Manufacturing · Saint Marys, GA
American Marine Design Corporation
According to OSHA enforcement records (2010–2026), American Marine Design Corporation ranks #74,007 of 99,447 penalized U.S. employers by total current penalty, with a average safety record: 4 violations across 3 inspections.
- $2,282
- OSHA penalties
- 4
- Violations cited
- 3
- OSHA inspections
- #74,007
- of 99,447 penalized employers
American Marine Design Corporation in Saint Marys, GA has been the subject of 3 OSHA workplace inspections and 4 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $2,282. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected American Marine Design Corporation 3 times across a longer 8-year span, an infrequent cadence. These inspections resulted in 4 violations, averaging 1.3 per inspection. According to OSHA enforcement records, its total current penalty ranks #74,007 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this sits roughly in line with peers (1.2x the sector average) on inspection frequency. For comparison, 51 North Brewery in Lake Orion, MI is another manufacturing employer with 0 OSHA inspections on record and $0 in current penalties.
- 1.3
- violations per inspection
- 50.0%
- of violations were serious
- #74,007
- of 99,447 penalized employers
Compliance score
- C OSHA safety compliance: 4 violations across 3 OSHA inspections (1.3 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How this employer compares on OSHA penalties
Total current penalty vs the Manufacturing per-employer average
- American Marine Design… $2,282
American Marine Design Corporation
$2,282 in penalties
- Manufacturing avg
Manufacturing industry average (per employer)
$15,763 in penalties
What this shows American Marine Design Corporation runs well below peers (0.14x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$2,282 Top 26% most affordable more affordable than 74% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is American Marine Design Corporation.
American Marine Design Corporation in the Manufacturing enforcement ledger
Among 35,243 Manufacturing employers with OSHA penalties on file, American Marine Design Corporation ranks #28,998 at $2,282 current penalty.
How American Marine Design Corporation Compares
American Marine Design Corporation's 1.33 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.
Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs well below peers (0.14x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
3
First Inspection
2016-06-13
Last Inspection
2024-11-12
Inspection Span
8 yrs
Violations / Inspection
1.3
Avg Penalty / Inspection
$761
Industry Avg / Inspection
$6,093
What this shows 3 inspections over 8 years, averaging 1.3 violations per visit. That's $761 per inspection vs. the Manufacturing average of $6,093.
Enforcement detail
Violation Breakdown
2
Serious
50.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
2
Other-Than-Serious
50.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$3,803
Current Penalty Amount
$2,282
Penalty Reduction
40.0%
What this shows Penalties were reduced by $1,521 from the initial assessment of $3,803. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Manufacturing
How American Marine Design Corporation compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.
| Metric | American Marine Design Corporation | Industry Avg |
|---|---|---|
| Inspections | 3 | 2.6 |
| Violations | 4 | 8.0 |
| Total Penalty | $2,282 | $15,763 |
| Avg Penalty per Inspection | $761 | $6,093 |
Nationwide Manufacturing peers with similar penalties or inspection counts
Two OSHA-record peer sets for American Marine Design Corporation, both outside GA so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($2,282 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (3 inspections here).
Nearby & Similar Employers in Manufacturing
Showing 5 of 44644 other employers tracked in this sector.
Compare American Marine Design Corporation vs American Metal Products, INC. side-by-side →
What to do with this record
Use American Marine Design Corporation's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare American Marine Design Corporation against American Metal Products, INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether American Marine Design Corporation's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is American Marine Design Corporation safe to work at? ▼
How many OSHA violations does American Marine Design Corporation have? ▼
How many OSHA inspections has American Marine Design Corporation had? ▼
What is the total penalty amount for American Marine Design Corporation? ▼
Does American Marine Design Corporation have any serious or willful violations? ▼
What industry does American Marine Design Corporation operate in? ▼
Where does American Marine Design Corporation rank nationally on OSHA penalties? ▼
How does American Marine Design Corporation's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.