PlainWorker
Employers › NJ

Manufacturing · Ledgewood, NJ

Adam Metal Products Company

According to OSHA enforcement records (2010–2026), Adam Metal Products Company ranks #12,382 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 16 violations across 5 inspections.

Top 25% by penalty69% serious
$26,565
OSHA penalties
16
Violations cited
5
OSHA inspections
#12,382
of 99,447 penalized employers

Adam Metal Products Company in Ledgewood, NJ has been the subject of 5 OSHA workplace inspections and 16 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $26,565. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Adam Metal Products Company 5 times over 3 years, roughly annually. These inspections resulted in 16 violations, averaging 3.2 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #12,382 of 99,447 penalized U.S. employers (the top quarter of penalized employers nationally). Of these, 11 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately above peers (1.9x the sector average) on inspection frequency. For comparison, Western Cabinets INC. in Cedar Hill, TX is another manufacturing employer with 5 OSHA inspections on record and $26,554 in current penalties.

3.2
violations per inspection
68.8%
of violations were serious
#12,382
of 99,447 penalized employers

Compliance score

F 43/100
  • F OSHA safety compliance: 16 violations across 5 OSHA inspections (3.2 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How Adam Metal Products Company compares on OSHA penalties

Total current penalty vs the Manufacturing per-employer average

in penalties

What this shows Adam Metal Products Company runs moderately above peers (1.7x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$26,565 Bottom 12% least affordable more affordable than 12% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). Below this entry. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Below this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Below this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Below this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Below this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). This entry sits in this band. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Adam Metal Products Company.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both5.05.055.05.03.716.329.041.654.3OSHA inspectionsViolations citedREX LUMBER, TROY, LLC, OSHA inspections: 5 · Violations cited: 11UPSTATE NIAGARA COOP…, OSHA inspections: 5 · Violations cited: 17NOAH'S ARK PROCESSOR…, OSHA inspections: 5 · Violations cited: 28JBS USA, LLC, OSHA inspections: 5 · Violations cited: 29CURT MANUFACTURING, …, OSHA inspections: 5 · Violations cited: 16SIVYER STEEL CORPORA…, OSHA inspections: 5 · Violations cited: 20LITTLE RAPIDS CORPOR…, OSHA inspections: 5 · Violations cited: 9DAYTON SUPERIOR CORP…, OSHA inspections: 5 · Violations cited: 17COSMO SPECIALTY FIBE…, OSHA inspections: 5 · Violations cited: 35DUNCAN GALVANIZING C…, OSHA inspections: 5 · Violations cited: 17RIZO LOPEZ FOODS, INC., OSHA inspections: 5 · Violations cited: 11BRANDT INDUSTRIES US…, OSHA inspections: 5 · Violations cited: 6GUPTA PERMOLD CORPOR…, OSHA inspections: 5 · Violations cited: 22NICHOLS ALUMINUM, LLC, OSHA inspections: 5 · Violations cited: 7NORANDA ALUMINUM, INC., OSHA inspections: 5 · Violations cited: 12AUGUSTA FIBERGLASS C…, OSHA inspections: 5 · Violations cited: 52VENTRA SANDUSKY, LLC, OSHA inspections: 5 · Violations cited: 11PANEL TRUSS - HEARNE…, OSHA inspections: 5 · Violations cited: 7PRIDE MANUFACTURING …, OSHA inspections: 5 · Violations cited: 14COLORADO ARCHITECTUR…, OSHA inspections: 5 · Violations cited: 20Adam Metal Products …, OSHA inspections: 5 · Violations cited: 16
Adam Metal Products Company has 5 OSHA inspections on record and 16 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Adam Metal Products Company in the Manufacturing enforcement ledger

In Manufacturing, Adam Metal Products Company sits at penalty rank #6,106 of 35,243 penalized establishments ($26,565 assessed).

How Adam Metal Products Company Compares

Adam Metal Products Company's 3.20 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately above peers (1.7x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

5

First Inspection

2011-03-09

Last Inspection

2014-03-04

Inspection Span

3 yrs

Violations / Inspection

3.2

Avg Penalty / Inspection

$5,313

Industry Avg / Inspection

$6,093

What this shows 5 inspections over 3 years, averaging 3.2 violations per visit. That's $5,313 per inspection vs. the Manufacturing average of $6,093.

Enforcement detail

Violation Breakdown

11

Serious

68.8% of total

0

Willful

0.0% of total

3

Repeat

18.8% of total

2

Other-Than-Serious

12.5% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$44,800

Current Penalty Amount

$26,565

Penalty Reduction

40.7%

What this shows Penalties were reduced by $18,235 from the initial assessment of $44,800. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How Adam Metal Products Company compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric Adam Metal Products Company Industry Avg
Inspections 5 2.6
Violations 16 8.0
Total Penalty $26,565 $15,763
Avg Penalty per Inspection $5,313 $6,093
View all 44,645 employers in Manufacturing →

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for Adam Metal Products Company, both outside NJ so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($26,565 here).

Buzzi Unicem USA $26,563 MS Maplegrove Gluten Free Foods INC. $26,575 CA Western Cabinets INC. $26,554 TX Idaho Timber of Carthage LLC $26,577 AR

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (5 inspections here).

Rex Lumber, Troy, LLC 5 insp. Troy, AL Upstate Niagara Cooperative, INC. 5 insp. Rochester, NY Noah's Ark Processors, LLC 5 insp. Hastings, NE JBS USA, LLC 5 insp. Greeley, CO

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Buzzi Unicem USA
Natchez, MS
2 inspections $26,563
Maplegrove Gluten Free Foods INC.
Fontana, CA
4 inspections $26,575
Western Cabinets INC.
Cedar Hill, TX
5 inspections $26,554
Idaho Timber of Carthage LLC
Carthage, AR
3 inspections $26,577
S & G Plastics
Houston, TX
1 inspections $12,800

Compare Adam Metal Products Company vs Buzzi Unicem USA side-by-side →

What to do with this record

Use Adam Metal Products Company's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Adam Metal Products Company against Buzzi Unicem USA, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Adam Metal Products Company's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Adam Metal Products Company safe to work at? ▼
Based on OSHA records, Adam Metal Products Company's workplace safety record is concerning, with multiple serious compliance issues. The employer has 16 violations across 5 inspections, including 11 serious violations. Compared to Manufacturing industry peers, this is above average for penalties. Review the full inspection history below for details.
How many OSHA violations does Adam Metal Products Company have? ▼
Adam Metal Products Company has 16 OSHA violations on record, including 11 serious, 0 willful, and 3 repeat violations. The total current penalty amount is $26,565.
How many OSHA inspections has Adam Metal Products Company had? ▼
Adam Metal Products Company has had 5 OSHA inspections, with the first recorded on 2011-03-09 and the most recent on 2014-03-04. This averages 3.2 violations per inspection.
What is the total penalty amount for Adam Metal Products Company? ▼
Adam Metal Products Company has been assessed $26,565 in current OSHA penalties, reduced from an initial assessment of $44,800 (a 40.7% reduction).
Does Adam Metal Products Company have any serious or willful violations? ▼
Yes. Adam Metal Products Company has 11 serious violations, and 3 repeat violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does Adam Metal Products Company operate in? ▼
Adam Metal Products Company operates in the Manufacturing sector (NAICS code 335122). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.
Where does Adam Metal Products Company rank nationally on OSHA penalties? ▼
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Adam Metal Products Company ranks #12,382 (the top quarter of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does Adam Metal Products Company's safety record compare to industry average? ▼
Adam Metal Products Company's total OSHA penalty of $26,565 is above the Manufacturing industry average of $15,763 per employer (1.7x the average). The employer has 5 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Western Cabinets INC. in Cedar Hill, TX is a similar manufacturing employer with $26,554 in current penalties.
Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 5 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.