PlainWorker
Employers › AL

Florence, AL

Total Support Tooling, INC.

According to OSHA enforcement records (2010–2026), Total Support Tooling, INC. ranks #65,138 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 5 violations across 2 inspections.

Lower half by penalty60% serious
$3,456
OSHA penalties
5
Violations cited
2
OSHA inspections
#65,138
of 99,447 penalized employers

Total Support Tooling, INC. in Florence, AL has been the subject of 2 OSHA workplace inspections and 5 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $3,456. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Total Support Tooling, INC. 2 times over 2 years, roughly annually. These inspections resulted in 5 violations, averaging 2.5 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #65,138 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 3 were classified as serious - indicating hazards that could cause death or serious harm. Against the Unknown industry average of 3 inspections per employer, this runs moderately below peers (0.7x the sector average) on inspection frequency. For comparison, Case & Associates in Wichita, KS is another unknown employer with 2 OSHA inspections on record and $3,500 in current penalties.

2.5
violations per inspection
60.0%
of violations were serious
#65,138
of 99,447 penalized employers

Compliance score

D 54/100
  • D OSHA safety compliance: 5 violations across 2 OSHA inspections (2.5 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How Total Support Tooling, INC. compares on OSHA penalties

Total current penalty vs the Unknown per-employer average

in penalties

What this shows Total Support Tooling, INC. sits roughly in line with peers (1.0x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$3,456 Top 34% most affordable more affordable than 66% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). This entry sits in this band. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Above this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Above this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Unknown employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Total Support Tooling, INC..

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both1.92.022.02.004.79.414.218.9OSHA inspectionsViolations citedROBERT C. JONES ALLO…, OSHA inspections: 2 · Violations cited: 5PENNZOIL QUICK LUBE, OSHA inspections: 2 · Violations cited: 2AMERCIAN IRON OXIDE …, OSHA inspections: 2 · Violations cited: 0JOSE ALFREDO SANTANA, OSHA inspections: 2 · Violations cited: 6SUMMERFIELD RETIREME…, OSHA inspections: 2 · Violations cited: 0THE METAL SHOP, OSHA inspections: 2 · Violations cited: 18SEKO WORLDWIDE LLC, OSHA inspections: 2 · Violations cited: 7ACME LITHOGRAPHERS, …, OSHA inspections: 2 · Violations cited: 0PEDRO ANTONIO RIVERA…, OSHA inspections: 2 · Violations cited: 4MUNROE INCORPORATED, OSHA inspections: 2 · Violations cited: 0VULCAN MATERIALS COM…, OSHA inspections: 2 · Violations cited: 1ASHEVILLE JET CHARTE…, OSHA inspections: 2 · Violations cited: 0LOWER MERION TOWNSHIP, OSHA inspections: 2 · Violations cited: 0PACKAGING CORPORATIO…, OSHA inspections: 2 · Violations cited: 1LOVELESS MANUFACTURING, OSHA inspections: 2 · Violations cited: 0CASE & ASSOCIATES, OSHA inspections: 2 · Violations cited: 1FLORIDA STEVEDORING,…, OSHA inspections: 2 · Violations cited: 0CUSTOM WELDING AND F…, OSHA inspections: 2 · Violations cited: 3WESTERN FABRICATION,…, OSHA inspections: 2 · Violations cited: 0MILLER & ASSOCIATES …, OSHA inspections: 2 · Violations cited: 2Total Support Toolin…, OSHA inspections: 2 · Violations cited: 5
Total Support Tooling, INC. has 2 OSHA inspections on record and 5 violations cited. The crosshair marks the median among these Unknown peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

How Total Support Tooling, INC. Compares

Total Support Tooling, INC.'s 2.50 violations per inspection compares to the Unknown sector average of 2.8 violations per employer.

Against the Unknown industry average of $3,328 per employer, this employer's current OSHA penalty sits roughly in line with peers (1.0x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

2

First Inspection

2013-02-28

Last Inspection

2014-12-10

Inspection Span

2 yrs

Violations / Inspection

2.5

Avg Penalty / Inspection

$1,728

Industry Avg / Inspection

$1,211

What this shows 2 inspections over 2 years, averaging 2.5 violations per visit. That's $1,728 per inspection vs. the Unknown average of $1,211.

Enforcement detail

Violation Breakdown

3

Serious

60.0% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

2

Other-Than-Serious

40.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$5,760

Current Penalty Amount

$3,456

Penalty Reduction

40.0%

What this shows Penalties were reduced by $2,304 from the initial assessment of $5,760. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Nationwide Unknown peers with similar penalties or inspection counts

Two OSHA-record peer sets for Total Support Tooling, INC., both outside AL so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($3,456 here).

Case & Associates $3,500 KS Socorro Ramirez Plancarte $3,400 KS TM Windows, LLC $3,360 FL Trusted & Reliable Healthcare, INC. $3,570 PA

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Robert C. Jones Alloys, INC. 2 insp. Huntington, WV Pennzoil Quick Lube 2 insp. Flint, MI Amercian Iron Oxide Company 2 insp. Allenport, PA Jose Alfredo Santana 2 insp. Los Angeles, CA

Nearby & Similar Employers in Unknown

Showing 5 of 177 other employers tracked in this sector.

Case & Associates
Wichita, KS
2 inspections $3,500
Socorro Ramirez Plancarte
Chanute, KS
2 inspections $3,400
TM Windows, LLC
Pompano Beach, FL
2 inspections $3,360
Trusted & Reliable Healthcare, INC.
Erie, PA
2 inspections $3,570
530 East 169th Street Owner, LLC
Bronx, NY
2 inspections $3,600

Compare Total Support Tooling, INC. vs Case & Associates side-by-side →

What to do with this record

Use Total Support Tooling, INC.'s enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Total Support Tooling, INC. against Case & Associates, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Total Support Tooling, INC.'s inspection and penalty record is typical for Unknown or an outlier against the sector's own average. View the Unknown sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Total Support Tooling, INC. safe to work at? ▼
Based on OSHA records, Total Support Tooling, INC.'s workplace safety record is mixed, with some compliance concerns. The employer has 5 violations across 2 inspections, including 3 serious violations. Compared to Unknown industry peers, this is above average for penalties. Review the full inspection history below for details.
How many OSHA violations does Total Support Tooling, INC. have? ▼
Total Support Tooling, INC. has 5 OSHA violations on record, including 3 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $3,456.
How many OSHA inspections has Total Support Tooling, INC. had? ▼
Total Support Tooling, INC. has had 2 OSHA inspections, with the first recorded on 2013-02-28 and the most recent on 2014-12-10. This averages 2.5 violations per inspection.
What is the total penalty amount for Total Support Tooling, INC.? ▼
Total Support Tooling, INC. has been assessed $3,456 in current OSHA penalties, reduced from an initial assessment of $5,760 (a 40.0% reduction).
Does Total Support Tooling, INC. have any serious or willful violations? ▼
Yes. Total Support Tooling, INC. has 3 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
Where does Total Support Tooling, INC. rank nationally on OSHA penalties? ▼
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Total Support Tooling, INC. ranks #65,138 (the lower half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does Total Support Tooling, INC.'s safety record compare to industry average? ▼
Total Support Tooling, INC.'s total OSHA penalty of $3,456 is above the Unknown industry average of $3,328 per employer (1.0x the average). The employer has 2 inspections compared to the industry average of 2.7 per employer. For a direct comparison, Case & Associates in Wichita, KS is a similar unknown employer with $3,500 in current penalties.
Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 2 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.