Construction · Camp Lejeune, NC
SPC Mechanical Corporation
According to OSHA enforcement records (2010–2026), SPC Mechanical Corporation ranks #77,630 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 2 violations across 2 inspections.
- $1,890
- OSHA penalties
- 2
- Violations cited
- 2
- OSHA inspections
- #77,630
- of 99,447 penalized employers
SPC Mechanical Corporation in Camp Lejeune, NC has been the subject of 2 OSHA workplace inspections and 2 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $1,890. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected SPC Mechanical Corporation 2 times over 1 year - more than twice a year on average. These inspections resulted in 2 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #77,630 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 1 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Neighborgall Construction CO. INC. in Huntington, WV is another construction employer with 10 OSHA inspections on record and $1,890 in current penalties.
- 1.0
- violations per inspection
- 50.0%
- of violations were serious
- #77,630
- of 99,447 penalized employers
Compliance score
- C OSHA safety compliance: 2 violations across 2 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How SPC Mechanical Corporation compares on OSHA penalties
Total current penalty vs the Construction per-employer average
- SPC Mechanical Corpora… $1,890
SPC Mechanical Corporation
$1,890 in penalties
- Construction avg
Construction industry average (per employer)
$6,767 in penalties
What this shows SPC Mechanical Corporation runs well below peers (0.28x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$1,890 Top 22% most affordable more affordable than 78% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is SPC Mechanical Corporation.
SPC Mechanical Corporation in the Construction enforcement ledger
Construction sector: SPC Mechanical Corporation is the #25,153 heaviest OSHA penalty carrier of 33,222 employers with nonzero fines ($1,890).
How SPC Mechanical Corporation Compares
SPC Mechanical Corporation's 1.00 violations per inspection compares to the Construction sector average of 3.3 violations per employer.
Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty runs well below peers (0.28x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2015-07-07
Last Inspection
2016-05-10
Inspection Span
1 yr
Violations / Inspection
1.0
Avg Penalty / Inspection
$945
Industry Avg / Inspection
$3,361
What this shows 2 inspections over 1 year, averaging 1.0 violations per visit. That's $945 per inspection vs. the Construction average of $3,361.
Enforcement detail
Violation Breakdown
1
Serious
50.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
1
Other-Than-Serious
50.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$6,300
Current Penalty Amount
$1,890
Penalty Reduction
70.0%
What this shows Penalties were reduced by $4,410 from the initial assessment of $6,300. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Construction
How SPC Mechanical Corporation compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.
| Metric | SPC Mechanical Corporation | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.0 |
| Violations | 2 | 3.3 |
| Total Penalty | $1,890 | $6,767 |
| Avg Penalty per Inspection | $945 | $3,361 |
Nationwide Construction peers with similar penalties or inspection counts
Two OSHA-record peer sets for SPC Mechanical Corporation, both outside NC so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($1,890 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Construction
Showing 5 of 61259 other employers tracked in this sector.
Compare SPC Mechanical Corporation vs D.P. Carney Construction INC. side-by-side →
What to do with this record
Use SPC Mechanical Corporation's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare SPC Mechanical Corporation against D.P. Carney Construction INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether SPC Mechanical Corporation's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is SPC Mechanical Corporation safe to work at? ▼
How many OSHA violations does SPC Mechanical Corporation have? ▼
How many OSHA inspections has SPC Mechanical Corporation had? ▼
What is the total penalty amount for SPC Mechanical Corporation? ▼
Does SPC Mechanical Corporation have any serious or willful violations? ▼
What industry does SPC Mechanical Corporation operate in? ▼
Where does SPC Mechanical Corporation rank nationally on OSHA penalties? ▼
How does SPC Mechanical Corporation's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.