PlainWorker
Employers › IN

Construction · Elkhart, IN

Morris Sheet Metal CORP

According to OSHA enforcement records (2010–2026), Morris Sheet Metal CORP has a relatively clean safety record: 0 violations across 3 inspections. See the full breakdown below.

$0
OSHA penalties
0
Violations cited
3
OSHA inspections

Morris Sheet Metal CORP in Elkhart, IN has been the subject of 3 OSHA workplace inspections and 0 citations since 2010, according to enforcement records from the U.S. Department of Labor. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Morris Sheet Metal CORP 3 times over 5 years, roughly once every couple of years. None of these inspections resulted in a citation. Against the Construction industry average of 2 inspections per employer, this runs moderately above peers (1.5x the sector average) on inspection frequency. For comparison, C. Abbonizio Contractors in Chester, PA is another construction employer with 2 OSHA inspections on record and $0 in current penalties.

0.0
violations per inspection
0.0%
of violations were serious

Compliance score

A 90/100
  • A OSHA safety compliance: 0 violations across 3 OSHA inspections (0.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Morris Sheet Metal CORP.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both3.03.033.03.005.511.016.522.1OSHA inspectionsViolations citedCHARM BUILDERS, LTD., OSHA inspections: 3 · Violations cited: 21JESUS ACOSTA VEGA, OSHA inspections: 3 · Violations cited: 12STRUCTURE USA CORP, OSHA inspections: 3 · Violations cited: 12KEYSTONE CONCRETE PL…, OSHA inspections: 3 · Violations cited: 11KINDEN CORPORATION, OSHA inspections: 3 · Violations cited: 9STATION BUILDERS, INC., OSHA inspections: 3 · Violations cited: 4BSA FRAMING INC., OSHA inspections: 3 · Violations cited: 4TZW CONTRACTING, OSHA inspections: 3 · Violations cited: 5IDAHO ROOFING CONTRA…, OSHA inspections: 3 · Violations cited: 3JOSE PEREZ PEREZ, OSHA inspections: 3 · Violations cited: 6BANEY CONSTRUCTION I…, OSHA inspections: 3 · Violations cited: 17JW MASONRY, OSHA inspections: 3 · Violations cited: 5PREMIER CONSTRUCTION…, OSHA inspections: 3 · Violations cited: 10GLENN O. HAWBAKER, I…, OSHA inspections: 3 · Violations cited: 3ST. FRANCIS ELECTRIC…, OSHA inspections: 3 · Violations cited: 8EVARISTO RAMIREZ, OSHA inspections: 3 · Violations cited: 5POST GENERAL CONTRAC…, OSHA inspections: 3 · Violations cited: 2J&L COMPANIES, INC, OSHA inspections: 3 · Violations cited: 3HGR GENERAL CONTRACT…, OSHA inspections: 3 · Violations cited: 2BIZZACK CONSTRUCTION…, OSHA inspections: 3 · Violations cited: 2Morris Sheet Metal C…, OSHA inspections: 3 · Violations cited: 0
Morris Sheet Metal CORP has 3 OSHA inspections on record and 0 violations cited. The crosshair marks the median among these Construction peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

How Morris Sheet Metal CORP Compares

3 OSHA inspections on record for Morris Sheet Metal CORP in Elkhart, IN, zero violations cited, a cleaner record than the Construction sector average of 3.3 violations per employer.

No OSHA penalty has been assessed against Morris Sheet Metal CORP to date. The Construction sector average runs $6,767 per employer.

Enforcement detail

OSHA Inspection History

Total Inspections

3

First Inspection

2010-02-23

Last Inspection

2014-10-07

Inspection Span

5 yrs

Violations / Inspection

0.0

Avg Penalty / Inspection

$0

Industry Avg / Inspection

$3,361

What this shows 3 inspections over 5 years, averaging 0.0 violations per visit. That's $0 per inspection vs. the Construction average of $3,361.

Industry Safety Context: Construction

How Morris Sheet Metal CORP compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.

Metric Morris Sheet Metal CORP Industry Avg
Inspections 3 2.0
Violations 0 3.3
Total Penalty $0 $6,767
Avg Penalty per Inspection $0 $3,361
View all 61,260 employers in Construction →

Nationwide Construction peers with similar penalties or inspection counts

Two OSHA-record peer sets for Morris Sheet Metal CORP, both outside IN so the neighborhoods are not geographic containment.

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (3 inspections here).

Charm Builders, LTD. 3 insp. Wheeling, WV Jesus Acosta Vega 3 insp. Midlothian, TX Structure USA CORP 3 insp. Brooklyn, NY Keystone Concrete Placement 3 insp. Austin, TX

Nearby & Similar Employers in Construction

Showing 5 of 61259 other employers tracked in this sector.

Nielsen Builders INC
Fishersville, VA
2 inspections $0
Colorado Roofing Exteriors LLC
Wheat Ridge, CO
2 inspections $0
C. Abbonizio Contractors
Chester, PA
2 inspections $0
Controlled Asbestos, INC.
Madrid, IA
2 inspections $0
Unknown
Clifton, NJ
3 inspections $0

Compare Morris Sheet Metal CORP vs Nielsen Builders INC side-by-side →

What to do with this record

Use Morris Sheet Metal CORP's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Morris Sheet Metal CORP against Nielsen Builders INC, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Morris Sheet Metal CORP's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Morris Sheet Metal CORP safe to work at? ▼
Based on OSHA records, Morris Sheet Metal CORP's workplace safety record is relatively clean, with fewer violations than typical. The employer has 0 violations across 3 inspections. Compared to Construction industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does Morris Sheet Metal CORP have? ▼
Morris Sheet Metal CORP has 0 OSHA violations on record, including 0 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $0.
How many OSHA inspections has Morris Sheet Metal CORP had? ▼
Morris Sheet Metal CORP has had 3 OSHA inspections, with the first recorded on 2010-02-23 and the most recent on 2014-10-07. This averages 0.0 violations per inspection.
What is the total penalty amount for Morris Sheet Metal CORP? ▼
Morris Sheet Metal CORP has been assessed $0 in current OSHA penalties.
What industry does Morris Sheet Metal CORP operate in? ▼
Morris Sheet Metal CORP operates in the Construction sector (NAICS code 238390). This industry has 61,260 employers tracked by PlainWorker, with 123,354 total OSHA inspections and $414.57M in cumulative penalties.
How does Morris Sheet Metal CORP's safety record compare to industry average? ▼
Morris Sheet Metal CORP's total OSHA penalty of $0 is below the Construction industry average of $6,767 per employer. The employer has 3 inspections compared to the industry average of 2.0 per employer. For a direct comparison, C. Abbonizio Contractors in Chester, PA is a similar construction employer with $0 in current penalties.
Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 3 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.