Wholesale Trade · Highland Park, MI
Micro Rim
According to OSHA enforcement records (2010–2026), Micro Rim ranks #66,148 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 8 violations across 2 inspections.
- $3,300
- OSHA penalties
- 8
- Violations cited
- 2
- OSHA inspections
- #66,148
- of 99,447 penalized employers
Micro Rim in Highland Park, MI has been the subject of 2 OSHA workplace inspections and 8 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $3,300. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Micro Rim 2 times over 1 year - more than twice a year on average. These inspections resulted in 8 violations, averaging 4.0 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #66,148 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 5 were classified as serious - indicating hazards that could cause death or serious harm. Against the Wholesale Trade industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Clearbrook Elevator Association in Clearbrook, MN is another wholesale trade employer with 2 OSHA inspections on record and $3,300 in current penalties.
- 4.0
- violations per inspection
- 62.5%
- of violations were serious
- #66,148
- of 99,447 penalized employers
Compliance score
- F OSHA safety compliance: 8 violations across 2 OSHA inspections (4.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How Micro Rim compares on OSHA penalties
Total current penalty vs the Wholesale Trade per-employer average
- Micro Rim $3,300
Micro Rim
$3,300 in penalties
- Wholesale Trade avg
Wholesale Trade industry average (per employer)
$9,112 in penalties
What this shows Micro Rim runs moderately below peers (0.4x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$3,300 Top 33% most affordable more affordable than 67% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Wholesale Trade employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Micro Rim.
Micro Rim in the Wholesale Trade enforcement ledger
In Wholesale Trade, Micro Rim sits at penalty rank #3,150 of 4,429 penalized establishments ($3,300 assessed).
How Micro Rim Compares
Micro Rim's 4.00 violations per inspection compares to the Wholesale Trade sector average of 5.5 violations per employer.
Against the Wholesale Trade industry average of $9,112 per employer, this employer's current OSHA penalty runs moderately below peers (0.4x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2024-08-27
Last Inspection
2024-09-11
Inspection Span
1 yr
Violations / Inspection
4.0
Avg Penalty / Inspection
$1,650
Industry Avg / Inspection
$4,665
What this shows 2 inspections over 1 year, averaging 4.0 violations per visit. That's $1,650 per inspection vs. the Wholesale Trade average of $4,665.
Enforcement detail
Violation Breakdown
5
Serious
62.5% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
3
Other-Than-Serious
37.5% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$6,600
Current Penalty Amount
$3,300
Penalty Reduction
50.0%
What this shows Penalties were reduced by $3,300 from the initial assessment of $6,600. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Wholesale Trade
How Micro Rim compares to the Wholesale Trade sector, which has 6,881 employers tracked by PlainWorker.
| Metric | Micro Rim | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.0 |
| Violations | 8 | 5.5 |
| Total Penalty | $3,300 | $9,112 |
| Avg Penalty per Inspection | $1,650 | $4,665 |
Nationwide Wholesale Trade peers with similar penalties or inspection counts
Two OSHA-record peer sets for Micro Rim, both outside MI so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($3,300 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Wholesale Trade
Showing 5 of 6880 other employers tracked in this sector.
What to do with this record
Use Micro Rim's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Micro Rim against Ceradyneviox, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Micro Rim's inspection and penalty record is typical for Wholesale Trade or an outlier against the sector's own average. View the Wholesale Trade sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Micro Rim safe to work at? ▼
How many OSHA violations does Micro Rim have? ▼
How many OSHA inspections has Micro Rim had? ▼
What is the total penalty amount for Micro Rim? ▼
Does Micro Rim have any serious or willful violations? ▼
What industry does Micro Rim operate in? ▼
Where does Micro Rim rank nationally on OSHA penalties? ▼
How does Micro Rim's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.