Construction · Philadelphia, PA

Maximum General Contracting

According to OSHA enforcement records (2010–2026), Maximum General Contracting ranks #13,055 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 11 violations across 3 inspections.

Top 25% by penalty82% serious
$25,500
OSHA penalties
11
Violations cited
3
OSHA inspections
#13,055
of 99,447 penalized employers

Maximum General Contracting in Philadelphia, PA has been the subject of 3 OSHA workplace inspections and 11 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $25,500. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Maximum General Contracting 3 times over 2 years, roughly annually. These inspections resulted in 11 violations, averaging 3.7 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #13,055 of 99,447 penalized U.S. employers (the top quarter of penalized employers nationally). Of these, 9 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this runs moderately above peers (1.5x the sector average) on inspection frequency. For comparison, Sasco in Los Angeles, CA is another construction employer with 3 OSHA inspections on record and $25,500 in current penalties.

3.7
violations per inspection
81.8%
of violations were serious
#13,055
of 99,447 penalized employers

Compliance score

F 37/100
  • F OSHA safety compliance: 11 violations across 3 OSHA inspections (3.7 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How Maximum General Contracting compares on OSHA penalties

Total current penalty vs the Construction per-employer average

in penalties

What this shows Maximum General Contracting runs well above peers (3.8x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$25,500 Bottom 13% least affordable more affordable than 13% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). Below this entry. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Below this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Below this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Below this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Below this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). This entry sits in this band. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Maximum General Contracting.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both3.03.033.03.01.25.61014.418.8OSHA inspectionsViolations citedFLINTLOCK CONSTRUCTI…, OSHA inspections: 3 · Violations cited: 12AFFORDABLE EXTERIORS…, OSHA inspections: 3 · Violations cited: 10BERLIN BUILDERS, INC., OSHA inspections: 3 · Violations cited: 7SUPERIOR LIGHTING, I…, OSHA inspections: 3 · Violations cited: 8ARMANDO IBARRA CONST…, OSHA inspections: 3 · Violations cited: 9APEK INCORPORATED, OSHA inspections: 3 · Violations cited: 5A. PREMAN ROOFING, I…, OSHA inspections: 3 · Violations cited: 7AMSTERDAM ENTERPRISE…, OSHA inspections: 3 · Violations cited: 6CITY OF OCEANSIDE, OSHA inspections: 3 · Violations cited: 5BUILDERS CONSTRUCTIO…, OSHA inspections: 3 · Violations cited: 3TOTAL NY CONSTRUCTION, OSHA inspections: 3 · Violations cited: 11THE MONAHAN CO., OSHA inspections: 3 · Violations cited: 18J V I BUILDERS GROUP…, OSHA inspections: 3 · Violations cited: 4CHS CONTRACTING LLC, OSHA inspections: 3 · Violations cited: 4WATER TIGHT ROOFING …, OSHA inspections: 3 · Violations cited: 8D.A.G. CONSTRUCTION …, OSHA inspections: 3 · Violations cited: 2SPRING SHEET METAL &…, OSHA inspections: 3 · Violations cited: 4SELECT QUALITY BUILD…, OSHA inspections: 3 · Violations cited: 5CENTRAL STATES ROOFI…, OSHA inspections: 3 · Violations cited: 2MILLER, POINEAU, AND…, OSHA inspections: 3 · Violations cited: 12Maximum General Cont…, OSHA inspections: 3 · Violations cited: 11
Maximum General Contracting has 3 OSHA inspections on record and 11 violations cited. The crosshair marks the median among these Construction peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Maximum General Contracting in the Construction enforcement ledger

In Construction, Maximum General Contracting sits at penalty rank #3,185 of 33,222 penalized establishments ($25,500 assessed).

How Maximum General Contracting Compares

Maximum General Contracting's 3.67 violations per inspection compares to the Construction sector average of 3.3 violations per employer.

Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty runs well above peers (3.8x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

3

First Inspection

2010-06-09

Last Inspection

2012-01-18

Inspection Span

2 yrs

Violations / Inspection

3.7

Avg Penalty / Inspection

$8,500

Industry Avg / Inspection

$3,361

What this shows 3 inspections over 2 years, averaging 3.7 violations per visit. That's $8,500 per inspection vs. the Construction average of $3,361.

Enforcement detail

Violation Breakdown

9

Serious

81.8% of total

0

Willful

0.0% of total

2

Repeat

18.2% of total

0

Other-Than-Serious

0.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$25,500

Current Penalty Amount

$25,500

Penalty Reduction

None

What this shows No reduction on record. The current penalty matches the original OSHA assessment.

Industry Safety Context: Construction

How Maximum General Contracting compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.

Metric Maximum General Contracting Industry Avg
Inspections 3 2.0
Violations 11 3.3
Total Penalty $25,500 $6,767
Avg Penalty per Inspection $8,500 $3,361

Nationwide Construction peers with similar penalties or inspection counts

Two OSHA-record peer sets for Maximum General Contracting, both outside PA so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($25,500 here).

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (3 inspections here).

Nearby & Similar Employers in Construction

Showing 5 of 61259 other employers tracked in this sector.

Compare Maximum General Contracting vs Stasi Brothers Asphalt CORP. side-by-side →

What to do with this record

Use Maximum General Contracting's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Maximum General Contracting against Stasi Brothers Asphalt CORP., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Maximum General Contracting's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Maximum General Contracting safe to work at?
Based on OSHA records, Maximum General Contracting's workplace safety record is concerning, with multiple serious compliance issues. The employer has 11 violations across 3 inspections, including 9 serious violations. Compared to Construction industry peers, this is above average for penalties. Review the full inspection history below for details.
How many OSHA violations does Maximum General Contracting have?
Maximum General Contracting has 11 OSHA violations on record, including 9 serious, 0 willful, and 2 repeat violations. The total current penalty amount is $25,500.
How many OSHA inspections has Maximum General Contracting had?
Maximum General Contracting has had 3 OSHA inspections, with the first recorded on 2010-06-09 and the most recent on 2012-01-18. This averages 3.7 violations per inspection.
What is the total penalty amount for Maximum General Contracting?
Maximum General Contracting has been assessed $25,500 in current OSHA penalties.
Does Maximum General Contracting have any serious or willful violations?
Yes. Maximum General Contracting has 9 serious violations, and 2 repeat violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does Maximum General Contracting operate in?
Maximum General Contracting operates in the Construction sector (NAICS code 238130). This industry has 61,260 employers tracked by PlainWorker, with 123,354 total OSHA inspections and $414.57M in cumulative penalties.
Where does Maximum General Contracting rank nationally on OSHA penalties?
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Maximum General Contracting ranks #13,055 (the top quarter of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does Maximum General Contracting's safety record compare to industry average?
Maximum General Contracting's total OSHA penalty of $25,500 is above the Construction industry average of $6,767 per employer (3.8x the average). The employer has 3 inspections compared to the industry average of 2.0 per employer. For a direct comparison, Sasco in Los Angeles, CA is a similar construction employer with $25,500 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 3 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.