Manufacturing · Scottdale, GA
Martin Sprocket & Gear, INC. of GA
According to OSHA enforcement records (2010–2026), Martin Sprocket & Gear, INC. of GA has a concerning safety record: 22 violations across 2 inspections. See the full breakdown below.
- $51,821
- OSHA penalties
- 22
- Violations cited
- 2
- OSHA inspections
- #4,819
- of 100,495 penalized employers
Martin Sprocket & Gear, INC. of GA in Scottdale, GA has been the subject of 2 OSHA workplace inspections and 22 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $51,821. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Martin Sprocket & Gear, INC. of GA 2 times over 2 years, roughly annually. These inspections turned up 22 violations, averaging 11.0 per inspection - an extremely dense concentration of citations. Its total OSHA penalty ranks in the top 5% of penalized employers nationally. Of these, 21 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately below peers (0.8x the sector average) on inspection frequency. For comparison, Idaho Pacific Colorado Corporation in Center, CO is another manufacturing employer with 4 OSHA inspections on record and $51,800 in current penalties.
- 11.0
- violations per inspection
- 95.5%
- of violations were serious
- 95%
- of penalized employers rank lower
How this employer compares on OSHA penalties
Total current penalty vs the Manufacturing per-employer average
- Martin Sprocket & Gear…
Martin Sprocket & Gear, INC. of GA
$51,821 in penalties
- Manufacturing avg $15,410
Manufacturing industry average (per employer)
$15,410 in penalties
What this shows Martin Sprocket & Gear, INC. of GA runs well above peers (3.4x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$51,821 Bottom 5% least affordable more affordable than 5% of 100,495 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
What the Data Says About Martin Sprocket & Gear, INC. of GA
The federal enforcement record for Martin Sprocket & Gear, INC. of GA in Scottdale, GA includes 2 OSHA inspections and 22 violations, translating to 11.00 violations per inspection. Of those violations, 21 (95.5%) were classified as serious, 0 (0.0%) as willful, and 0 (0.0%) as repeat. Serious violations denote hazards likely to cause death or serious physical harm; willful and repeat categories indicate intentional disregard or recurrence of previously cited hazards.
OSHA assessed $73,949 in initial penalties against this employer, later adjusted to a current total of $51,821 - a 29.9% reduction. Average penalty per inspection works out to $25,911. Against the Manufacturing industry average of $15,410 per employer, this record runs well above peers (3.4x the sector average).
Inspection activity spans from 2014-07-03 to 2016-12-07, a window of roughly 2 years.
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2014-07-03
Last Inspection
2016-12-07
Inspection Span
2 yrs
Violations / Inspection
11.0
Avg Penalty / Inspection
$25,911
Industry Avg / Inspection
$6,092
What this shows 2 inspections over 2 years, averaging 11.0 violations per visit. That's $25,911 per inspection vs. the Manufacturing average of $6,092.
Enforcement detail
Violation Breakdown
21
Serious
95.5% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
1
Other-Than-Serious
4.5% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$73,949
Current Penalty Amount
$51,821
Penalty Reduction
29.9%
What this shows Penalties were reduced by $22,128 from the initial assessment of $73,949. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Manufacturing
How Martin Sprocket & Gear, INC. of GA compares to the Manufacturing sector, which has 45,665 employers tracked by PlainWorker.
| Metric | Martin Sprocket & Gear, INC. of GA | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.5 |
| Violations | 22 | 7.8 |
| Total Penalty | $51,821 | $15,410 |
| Avg Penalty per Inspection | $25,911 | $6,092 |
Nearby & Similar Employers in Manufacturing
Compare Martin Sprocket & Gear, INC. of GA vs The Medalcraft Mint, INC. side-by-side →
Frequently Asked Questions
Is Martin Sprocket & Gear, INC. of GA safe to work at? ▼
How many OSHA violations does Martin Sprocket & Gear, INC. of GA have? ▼
How many OSHA inspections has Martin Sprocket & Gear, INC. of GA had? ▼
What is the total penalty amount for Martin Sprocket & Gear, INC. of GA? ▼
Does Martin Sprocket & Gear, INC. of GA have any serious or willful violations? ▼
What industry does Martin Sprocket & Gear, INC. of GA operate in? ▼
How does Martin Sprocket & Gear, INC. of GA's safety record compare to industry average? ▼
Explore PlainWorker
What to check next
Martin Sprocket & Gear, INC. of GA's record is one establishment in a larger pattern. Use it as a research checklist, not a verdict on the employer overall.
- See how Martin Sprocket & Gear, INC. of GA compares to the 45,665 other employers in Manufacturing. Manufacturing record
- Put this employer head-to-head with another on inspections, penalties, and back wages. Compare employers
- Review the full OSHA & wage-enforcement picture for GA. GA state record
These figures are the federal enforcement record on file and reflect past inspections, not a statement about current workplace conditions. See the disclaimer for how to read them.
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.