Manufacturing · Erin, TN

Magnum Manufacturing, INC.

According to OSHA enforcement records (2010–2026), Magnum Manufacturing, INC. ranks #42,184 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 21 violations across 2 inspections.

Upper half by penalty33% serious

Compiled by Plainworker · September 6, 2026

$7,820
OSHA penalties: 21
Violations cited: 2
OSHA inspections: #42,184
of 99,447 penalized employers

Magnum Manufacturing, INC. in Erin, TN has been the subject of 2 OSHA workplace inspections and 21 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $7,820. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Magnum Manufacturing, INC. 2 times over 2 years, roughly annually. These inspections turned up 21 violations, averaging 10.5 per inspection - an extremely dense concentration of citations. According to OSHA enforcement records, its total current penalty ranks #42,184 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 7 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately below peers (0.8x the sector average) on inspection frequency. For comparison, Precision Delta Corporation in Ruleville, MS is another manufacturing employer with 2 OSHA inspections on record and $7,822 in current penalties.

10.5
violations per inspection: 33.3%
of violations were serious: #42,184
of 99,447 penalized employers

Compliance score

F 0/100

F OSHA safety compliance: 21 violations across 2 OSHA inspections (10.5 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Magnum Manufacturing, …

$7,820
Manufacturing avg

$15,763

What this shows Magnum Manufacturing, INC. runs moderately below peers (0.5x the sector average) in total OSHA penalties.

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$7,820 Bottom 42% least affordable more affordable than 42% of 99,447 U.S. employers with a penalty

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Magnum Manufacturing, INC..

Magnum Manufacturing, INC. has 2 OSHA inspections on record and 21 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Magnum Manufacturing, INC. in the Manufacturing enforcement ledger

In Manufacturing, Magnum Manufacturing, INC. sits at penalty rank #18,497 of 35,243 penalized establishments ($7,820 assessed).

How Magnum Manufacturing, INC. Compares

Magnum Manufacturing, INC.'s 10.50 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately below peers (0.5x the sector average).

Total Inspections

First Inspection

2015-04-30

Last Inspection

2017-10-17

Inspection Span

2 yrs

Violations / Inspection

10.5

Avg Penalty / Inspection

$3,910

Industry Avg / Inspection

$6,093

What this shows 2 inspections over 2 years, averaging 10.5 violations per visit. That's $3,910 per inspection vs. the Manufacturing average of $6,093.

Serious

33.3% of total

Willful

0.0% of total

Repeat

0.0% of total

Other-Than-Serious

66.7% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Initial Penalty Assessed

$9,550

Current Penalty Amount

$7,820

Penalty Reduction

18.1%

What this shows Penalties were reduced by $1,730 from the initial assessment of $9,550. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How Magnum Manufacturing, INC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric	Magnum Manufacturing, INC.	Industry Avg
Inspections	2	2.6
Violations	21	8.0
Total Penalty	$7,820	$15,763
Avg Penalty per Inspection	$3,910	$6,093

View all 44,645 employers in Manufacturing →

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for Magnum Manufacturing, INC., both outside TN so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($7,820 here).

Jayhawk Boxes, INC. $7,820 NE Lou's Doors, INC. $7,820 CA River Town Ironworks INC $7,821 WI Precision Delta Corporation $7,822 MS

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Republic Engineered Products INC. 2 insp. Lorain, OH Berry Global, INC. 2 insp. Sterling, MA Heidelberg Materials Northeast LLC 2 insp. Nazareth, PA R & E Pallets, Inc 2 insp. Michigan City, IN

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

River Town Ironworks INC

Prairie Du Chien, WI

2 inspections $7,821

Precision Delta Corporation

Compare Magnum Manufacturing, INC. vs Jayhawk Boxes, INC. side-by-side →

What to do with this record

Use Magnum Manufacturing, INC.'s enforcement history as one data point, not the whole picture.

A single employer's record can look unusual in isolation. Compare Magnum Manufacturing, INC. against Jayhawk Boxes, INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
See whether Magnum Manufacturing, INC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Magnum Manufacturing, INC. safe to work at? ▼

Based on OSHA records, Magnum Manufacturing, INC.'s workplace safety record is concerning, with multiple serious compliance issues. The employer has 21 violations across 2 inspections, including 7 serious violations. Compared to Manufacturing industry peers, this is below average for penalties. Review the full inspection history below for details.

How many OSHA violations does Magnum Manufacturing, INC. have? ▼

Magnum Manufacturing, INC. has 21 OSHA violations on record, including 7 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $7,820.

How many OSHA inspections has Magnum Manufacturing, INC. had? ▼

Magnum Manufacturing, INC. has had 2 OSHA inspections, with the first recorded on 2015-04-30 and the most recent on 2017-10-17. This averages 10.5 violations per inspection.

What is the total penalty amount for Magnum Manufacturing, INC.? ▼

Magnum Manufacturing, INC. has been assessed $7,820 in current OSHA penalties, reduced from an initial assessment of $9,550 (a 18.1% reduction).

Does Magnum Manufacturing, INC. have any serious or willful violations? ▼

Yes. Magnum Manufacturing, INC. has 7 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.

What industry does Magnum Manufacturing, INC. operate in? ▼

Magnum Manufacturing, INC. operates in the Manufacturing sector (NAICS code 332322). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.

Where does Magnum Manufacturing, INC. rank nationally on OSHA penalties? ▼

Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Magnum Manufacturing, INC. ranks #42,184 (the upper half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.

How does Magnum Manufacturing, INC.'s safety record compare to industry average? ▼

Magnum Manufacturing, INC.'s total OSHA penalty of $7,820 is below the Manufacturing industry average of $15,763 per employer. The employer has 2 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Precision Delta Corporation in Ruleville, MS is a similar manufacturing employer with $7,822 in current penalties.

Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.