Manufacturing · Ocala, FL

J2 Cabinetry and Trim, LLC.

According to OSHA enforcement records (2010–2026), J2 Cabinetry and Trim, LLC. ranks #40,468 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 3 violations across 2 inspections.

Upper half by penalty100% serious
$8,298
OSHA penalties
3
Violations cited
2
OSHA inspections
#40,468
of 99,447 penalized employers

J2 Cabinetry and Trim, LLC. in Ocala, FL has been the subject of 2 OSHA workplace inspections and 3 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $8,298. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected J2 Cabinetry and Trim, LLC. 2 times over 2 years, roughly annually. These inspections resulted in 3 violations, averaging 1.5 per inspection. According to OSHA enforcement records, its total current penalty ranks #40,468 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 3 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately below peers (0.8x the sector average) on inspection frequency. For comparison, Versatex Building Products, LLC in Aliquippa, PA is another manufacturing employer with 4 OSHA inspections on record and $8,300 in current penalties.

1.5
violations per inspection
100.0%
of violations were serious
#40,468
of 99,447 penalized employers

Compliance score

C 68/100
  • C OSHA safety compliance: 3 violations across 2 OSHA inspections (1.5 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How J2 Cabinetry and Trim, LLC. compares on OSHA penalties

Total current penalty vs the Manufacturing per-employer average

in penalties

What this shows J2 Cabinetry and Trim, LLC. runs moderately below peers (0.5x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$8,298 Bottom 41% least affordable more affordable than 41% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). Below this entry. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). This entry sits in this band. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Above this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is J2 Cabinetry and Trim, LLC..

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both1.92.022.02.00.39.919.529.138.8OSHA inspectionsViolations citedREGAL INDUSTRIAL COR…, OSHA inspections: 2 · Violations cited: 23SOMACIS INC., OSHA inspections: 2 · Violations cited: 12LAB 9 MODULAR LLC, OSHA inspections: 2 · Violations cited: 12TWITCHELL CORPORATION, OSHA inspections: 2 · Violations cited: 22CHEP RECYCLED PALLET…, OSHA inspections: 2 · Violations cited: 6GRAHAM LUMBER COMPAN…, OSHA inspections: 2 · Violations cited: 2ACH FOAM TECHNOLOGIE…, OSHA inspections: 2 · Violations cited: 13TIGHITCO, INC., OSHA inspections: 2 · Violations cited: 16AMERICAN MADE TIRES, OSHA inspections: 2 · Violations cited: 37U.S. PAPER MILLS CORP., OSHA inspections: 2 · Violations cited: 8WINCO/DWL INTERNATIO…, OSHA inspections: 2 · Violations cited: 8INTEGRATED LAMINATE …, OSHA inspections: 2 · Violations cited: 29TBRSP, LLC, OSHA inspections: 2 · Violations cited: 23SIGNATURE CABINETRY, OSHA inspections: 2 · Violations cited: 15MILLWORK EXPRESSIONS…, OSHA inspections: 2 · Violations cited: 28MB DYNAMICS INC., OSHA inspections: 2 · Violations cited: 33SOUTHERN FOREST PROD…, OSHA inspections: 2 · Violations cited: 12KRAFT HEINZ FOODS CO…, OSHA inspections: 2 · Violations cited: 6NASHVILLE FABRICATIO…, OSHA inspections: 2 · Violations cited: 29HARD ROCK STONE & TI…, OSHA inspections: 2 · Violations cited: 15J2 Cabinetry and Tri…, OSHA inspections: 2 · Violations cited: 3
J2 Cabinetry and Trim, LLC. has 2 OSHA inspections on record and 3 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

J2 Cabinetry and Trim, LLC. in the Manufacturing enforcement ledger

Among 35,243 Manufacturing employers with OSHA penalties on file, J2 Cabinetry and Trim, LLC. ranks #17,881 at $8,298 current penalty.

How J2 Cabinetry and Trim, LLC. Compares

J2 Cabinetry and Trim, LLC.'s 1.50 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately below peers (0.5x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

2

First Inspection

2024-03-25

Last Inspection

2026-02-25

Inspection Span

2 yrs

Violations / Inspection

1.5

Avg Penalty / Inspection

$4,149

Industry Avg / Inspection

$6,093

What this shows 2 inspections over 2 years, averaging 1.5 violations per visit. That's $4,149 per inspection vs. the Manufacturing average of $6,093.

Enforcement detail

Violation Breakdown

3

Serious

100.0% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

0

Other-Than-Serious

0.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$13,830

Current Penalty Amount

$8,298

Penalty Reduction

40.0%

What this shows Penalties were reduced by $5,532 from the initial assessment of $13,830. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How J2 Cabinetry and Trim, LLC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric J2 Cabinetry and Trim, LLC. Industry Avg
Inspections 2 2.6
Violations 3 8.0
Total Penalty $8,298 $15,763
Avg Penalty per Inspection $4,149 $6,093

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for J2 Cabinetry and Trim, LLC., both outside FL so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($8,298 here).

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (2 inspections here).

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Compare J2 Cabinetry and Trim, LLC. vs Martin's Famous Pastry Shoppe, INC. side-by-side →

What to do with this record

Use J2 Cabinetry and Trim, LLC.'s enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare J2 Cabinetry and Trim, LLC. against Martin's Famous Pastry Shoppe, INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether J2 Cabinetry and Trim, LLC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is J2 Cabinetry and Trim, LLC. safe to work at?
Based on OSHA records, J2 Cabinetry and Trim, LLC.'s workplace safety record is mixed, with some compliance concerns. The employer has 3 violations across 2 inspections, including 3 serious violations. Compared to Manufacturing industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does J2 Cabinetry and Trim, LLC. have?
J2 Cabinetry and Trim, LLC. has 3 OSHA violations on record, including 3 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $8,298.
How many OSHA inspections has J2 Cabinetry and Trim, LLC. had?
J2 Cabinetry and Trim, LLC. has had 2 OSHA inspections, with the first recorded on 2024-03-25 and the most recent on 2026-02-25. This averages 1.5 violations per inspection.
What is the total penalty amount for J2 Cabinetry and Trim, LLC.?
J2 Cabinetry and Trim, LLC. has been assessed $8,298 in current OSHA penalties, reduced from an initial assessment of $13,830 (a 40.0% reduction).
Does J2 Cabinetry and Trim, LLC. have any serious or willful violations?
Yes. J2 Cabinetry and Trim, LLC. has 3 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does J2 Cabinetry and Trim, LLC. operate in?
J2 Cabinetry and Trim, LLC. operates in the Manufacturing sector (NAICS code 337110). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.
Where does J2 Cabinetry and Trim, LLC. rank nationally on OSHA penalties?
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, J2 Cabinetry and Trim, LLC. ranks #40,468 (the upper half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does J2 Cabinetry and Trim, LLC.'s safety record compare to industry average?
J2 Cabinetry and Trim, LLC.'s total OSHA penalty of $8,298 is below the Manufacturing industry average of $15,763 per employer. The employer has 2 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Versatex Building Products, LLC in Aliquippa, PA is a similar manufacturing employer with $8,300 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 2 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.