Manufacturing · Suwanee, GA
Gwinnett Lumber Remanufacturing, INC.
According to OSHA enforcement records (2010–2026), Gwinnett Lumber Remanufacturing, INC. ranks #12,305 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 16 violations across 3 inspections.
- $26,723
- OSHA penalties
- 16
- Violations cited
- 3
- OSHA inspections
- #12,305
- of 99,447 penalized employers
Gwinnett Lumber Remanufacturing, INC. in Suwanee, GA has been the subject of 3 OSHA workplace inspections and 16 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $26,723. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Gwinnett Lumber Remanufacturing, INC. 3 times over 2 years, roughly annually. These inspections resulted in 16 violations, averaging 5.3 per inspection - a notably high rate. According to OSHA enforcement records, its total current penalty ranks #12,305 of 99,447 penalized U.S. employers (the top quarter of penalized employers nationally). Of these, 16 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this sits roughly in line with peers (1.2x the sector average) on inspection frequency. For comparison, Edro Engineering, INC. in Walnut, CA is another manufacturing employer with 2 OSHA inspections on record and $26,712 in current penalties.
- 5.3
- violations per inspection
- 100.0%
- of violations were serious
- #12,305
- of 99,447 penalized employers
Compliance score
- F OSHA safety compliance: 16 violations across 3 OSHA inspections (5.3 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How this employer compares on OSHA penalties
Total current penalty vs the Manufacturing per-employer average
- Gwinnett Lumber Remanu…
Gwinnett Lumber Remanufacturing, INC.
$26,723 in penalties
- Manufacturing avg
Manufacturing industry average (per employer)
$15,763 in penalties
What this shows Gwinnett Lumber Remanufacturing, INC. runs moderately above peers (1.7x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$26,723 Bottom 12% least affordable more affordable than 12% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Gwinnett Lumber Remanufacturing, INC..
Gwinnett Lumber Remanufacturing, INC. in the Manufacturing enforcement ledger
In Manufacturing, Gwinnett Lumber Remanufacturing, INC. sits at penalty rank #6,071 of 35,243 penalized establishments ($26,723 assessed).
How Gwinnett Lumber Remanufacturing, INC. Compares
Gwinnett Lumber Remanufacturing, INC.'s 5.33 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.
Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately above peers (1.7x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
3
First Inspection
2016-06-07
Last Inspection
2018-02-28
Inspection Span
2 yrs
Violations / Inspection
5.3
Avg Penalty / Inspection
$8,908
Industry Avg / Inspection
$6,093
What this shows 3 inspections over 2 years, averaging 5.3 violations per visit. That's $8,908 per inspection vs. the Manufacturing average of $6,093.
Enforcement detail
Violation Breakdown
16
Serious
100.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
0
Other-Than-Serious
0.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$44,539
Current Penalty Amount
$26,723
Penalty Reduction
40.0%
What this shows Penalties were reduced by $17,816 from the initial assessment of $44,539. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Manufacturing
How Gwinnett Lumber Remanufacturing, INC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.
| Metric | Gwinnett Lumber Remanufacturing, INC. | Industry Avg |
|---|---|---|
| Inspections | 3 | 2.6 |
| Violations | 16 | 8.0 |
| Total Penalty | $26,723 | $15,763 |
| Avg Penalty per Inspection | $8,908 | $6,093 |
Nationwide Manufacturing peers with similar penalties or inspection counts
Two OSHA-record peer sets for Gwinnett Lumber Remanufacturing, INC., both outside GA so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($26,723 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (3 inspections here).
Nearby & Similar Employers in Manufacturing
Showing 5 of 44644 other employers tracked in this sector.
Compare Gwinnett Lumber Remanufacturing, INC. vs Ampro side-by-side →
What to do with this record
Use Gwinnett Lumber Remanufacturing, INC.'s enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Gwinnett Lumber Remanufacturing, INC. against Ampro, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Gwinnett Lumber Remanufacturing, INC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Gwinnett Lumber Remanufacturing, INC. safe to work at? ▼
How many OSHA violations does Gwinnett Lumber Remanufacturing, INC. have? ▼
How many OSHA inspections has Gwinnett Lumber Remanufacturing, INC. had? ▼
What is the total penalty amount for Gwinnett Lumber Remanufacturing, INC.? ▼
Does Gwinnett Lumber Remanufacturing, INC. have any serious or willful violations? ▼
What industry does Gwinnett Lumber Remanufacturing, INC. operate in? ▼
Where does Gwinnett Lumber Remanufacturing, INC. rank nationally on OSHA penalties? ▼
How does Gwinnett Lumber Remanufacturing, INC.'s safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.