Wholesale Trade · ST Paul, MN
Great Western Iron & Metal CO DBA Northern Metal
According to OSHA enforcement records (2010–2026), Great Western Iron & Metal CO DBA Northern Metal ranks #77,111 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 2 violations across 2 inspections.
- $1,960
- OSHA penalties
- 2
- Violations cited
- 2
- OSHA inspections
- #77,111
- of 99,447 penalized employers
Great Western Iron & Metal CO DBA Northern Metal in ST Paul, MN has been the subject of 2 OSHA workplace inspections and 2 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $1,960. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Great Western Iron & Metal CO DBA Northern Metal 2 times over 3 years, roughly once every couple of years. These inspections resulted in 2 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #77,111 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Wholesale Trade industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Bulbman, INC. in Reno, NV is another wholesale trade employer with 2 OSHA inspections on record and $1,960 in current penalties.
- 1.0
- violations per inspection
- 100.0%
- of violations were serious
- #77,111
- of 99,447 penalized employers
Compliance score
- C OSHA safety compliance: 2 violations across 2 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How this employer compares on OSHA penalties
Total current penalty vs the Wholesale Trade per-employer average
- Great Western Iron & M… $1,960
Great Western Iron & Metal CO DBA Northern Metal
$1,960 in penalties
- Wholesale Trade avg
Wholesale Trade industry average (per employer)
$9,112 in penalties
What this shows Great Western Iron & Metal CO DBA Northern Metal runs well below peers (0.22x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$1,960 Top 22% most affordable more affordable than 78% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Wholesale Trade employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Great Western Iron & Metal CO DBA Northern Metal.
Great Western Iron & Metal CO DBA Northern Metal in the Wholesale Trade enforcement ledger
Among 4,429 Wholesale Trade employers with OSHA penalties on file, Great Western Iron & Metal CO DBA Northern Metal ranks #3,632 at $1,960 current penalty.
How Great Western Iron & Metal CO DBA Northern Metal Compares
Great Western Iron & Metal CO DBA Northern Metal's 1.00 violations per inspection compares to the Wholesale Trade sector average of 5.5 violations per employer.
Against the Wholesale Trade industry average of $9,112 per employer, this employer's current OSHA penalty runs well below peers (0.22x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2011-03-18
Last Inspection
2013-12-13
Inspection Span
3 yrs
Violations / Inspection
1.0
Avg Penalty / Inspection
$980
Industry Avg / Inspection
$4,665
What this shows 2 inspections over 3 years, averaging 1.0 violations per visit. That's $980 per inspection vs. the Wholesale Trade average of $4,665.
Enforcement detail
Violation Breakdown
2
Serious
100.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
0
Other-Than-Serious
0.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$2,800
Current Penalty Amount
$1,960
Penalty Reduction
30.0%
What this shows Penalties were reduced by $840 from the initial assessment of $2,800. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Wholesale Trade
How Great Western Iron & Metal CO DBA Northern Metal compares to the Wholesale Trade sector, which has 6,881 employers tracked by PlainWorker.
| Metric | Great Western Iron & Metal CO DBA Northern Metal | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.0 |
| Violations | 2 | 5.5 |
| Total Penalty | $1,960 | $9,112 |
| Avg Penalty per Inspection | $980 | $4,665 |
Nationwide Wholesale Trade peers with similar penalties or inspection counts
Two OSHA-record peer sets for Great Western Iron & Metal CO DBA Northern Metal, both outside MN so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($1,960 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Wholesale Trade
Showing 5 of 6880 other employers tracked in this sector.
What to do with this record
Use Great Western Iron & Metal CO DBA Northern Metal's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Great Western Iron & Metal CO DBA Northern Metal against United States Steel Corporation DBA US Steel, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Great Western Iron & Metal CO DBA Northern Metal's inspection and penalty record is typical for Wholesale Trade or an outlier against the sector's own average. View the Wholesale Trade sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Great Western Iron & Metal CO DBA Northern Metal safe to work at? ▼
How many OSHA violations does Great Western Iron & Metal CO DBA Northern Metal have? ▼
How many OSHA inspections has Great Western Iron & Metal CO DBA Northern Metal had? ▼
What is the total penalty amount for Great Western Iron & Metal CO DBA Northern Metal? ▼
Does Great Western Iron & Metal CO DBA Northern Metal have any serious or willful violations? ▼
What industry does Great Western Iron & Metal CO DBA Northern Metal operate in? ▼
Where does Great Western Iron & Metal CO DBA Northern Metal rank nationally on OSHA penalties? ▼
How does Great Western Iron & Metal CO DBA Northern Metal's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.