PlainWorker
Employers › NE

Manufacturing · Wayne, NE

Great Dane Limited Partnership

According to OSHA enforcement records (2010–2026), Great Dane Limited Partnership ranks #30,567 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 4 violations across 4 inspections.

Upper half by penalty50% serious
$11,750
OSHA penalties
4
Violations cited
4
OSHA inspections
#30,567
of 99,447 penalized employers

Great Dane Limited Partnership in Wayne, NE has been the subject of 4 OSHA workplace inspections and 4 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $11,750. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Great Dane Limited Partnership 4 times over 4 years, roughly annually. These inspections resulted in 4 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #30,567 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately above peers (1.5x the sector average) on inspection frequency. For comparison, R & D Tool & Engineering Company in Lees Summit, MO is another manufacturing employer with 2 OSHA inspections on record and $11,750 in current penalties.

1.0
violations per inspection
50.0%
of violations were serious
#30,567
of 99,447 penalized employers

Compliance score

C 75/100
  • C OSHA safety compliance: 4 violations across 4 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How Great Dane Limited Partnership compares on OSHA penalties

Total current penalty vs the Manufacturing per-employer average

in penalties

What this shows Great Dane Limited Partnership runs moderately below peers (0.7x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$11,750 Bottom 31% least affordable more affordable than 31% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). Below this entry. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Below this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). This entry sits in this band. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Great Dane Limited Partnership.

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both4.04.044.04.02.45.7912.315.6OSHA inspectionsViolations citedKOCH FOODS OF CINCIN…, OSHA inspections: 4 · Violations cited: 7PHILADELPHIA MACARON…, OSHA inspections: 4 · Violations cited: 6REGAL BELOIT AMERICA…, OSHA inspections: 4 · Violations cited: 13MANDO AMERICA CORPOR…, OSHA inspections: 4 · Violations cited: 13CAMPAGNA-TURANO BAKE…, OSHA inspections: 4 · Violations cited: 8MAPLE DONUTS, INC., OSHA inspections: 4 · Violations cited: 14NATIONAL OILWELL VARCO, OSHA inspections: 4 · Violations cited: 15CONECSUS, LLC, OSHA inspections: 4 · Violations cited: 11TOMRIC SYSTEMS, INC., OSHA inspections: 4 · Violations cited: 7RICHELIEU FOODS INC., OSHA inspections: 4 · Violations cited: 4AUSTIN URETHANE, INC., OSHA inspections: 4 · Violations cited: 11TYSON FARMS, INC., OSHA inspections: 4 · Violations cited: 6CHIPS INC., OSHA inspections: 4 · Violations cited: 4CAMGER COATINGS SYST…, OSHA inspections: 4 · Violations cited: 10A. ZEREGA'S SONS, INC., OSHA inspections: 4 · Violations cited: 3NESTLE PREPARED FOOD…, OSHA inspections: 4 · Violations cited: 4CONTINENTAL CASTING,…, OSHA inspections: 4 · Violations cited: 12STEEL KING INDUSTRIE…, OSHA inspections: 4 · Violations cited: 3THE PROCTER & GAMBLE…, OSHA inspections: 4 · Violations cited: 4HENTZEN COATINGS, INC., OSHA inspections: 4 · Violations cited: 5Great Dane Limited P…, OSHA inspections: 4 · Violations cited: 4
Great Dane Limited Partnership has 4 OSHA inspections on record and 4 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Great Dane Limited Partnership in the Manufacturing enforcement ledger

Among 35,243 Manufacturing employers with OSHA penalties on file, Great Dane Limited Partnership ranks #14,044 at $11,750 current penalty.

How Great Dane Limited Partnership Compares

Great Dane Limited Partnership's 1.00 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs moderately below peers (0.7x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

4

First Inspection

2011-06-23

Last Inspection

2015-04-23

Inspection Span

4 yrs

Violations / Inspection

1.0

Avg Penalty / Inspection

$2,938

Industry Avg / Inspection

$6,093

What this shows 4 inspections over 4 years, averaging 1.0 violations per visit. That's $2,938 per inspection vs. the Manufacturing average of $6,093.

Enforcement detail

Violation Breakdown

2

Serious

50.0% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

2

Other-Than-Serious

50.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$19,250

Current Penalty Amount

$11,750

Penalty Reduction

39.0%

What this shows Penalties were reduced by $7,500 from the initial assessment of $19,250. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How Great Dane Limited Partnership compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric Great Dane Limited Partnership Industry Avg
Inspections 4 2.6
Violations 4 8.0
Total Penalty $11,750 $15,763
Avg Penalty per Inspection $2,938 $6,093
View all 44,645 employers in Manufacturing →

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for Great Dane Limited Partnership, both outside NE so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($11,750 here).

Hydrite Chemical Company $11,750 IA Atlas Iron Works $11,750 MO Tenac INC $11,750 TN Grand Rapids Plastics $11,750 MI

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (4 inspections here).

Koch Foods of Cincinnati, LLC 4 insp. Fairfield, OH Philadelphia Macaroni Company 4 insp. Grand Forks, ND Regal Beloit America, INC. 4 insp. McAllen, TX Mando America Corporation 4 insp. Hogansville, GA

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Hydrite Chemical Company
Waterloo, IA
3 inspections $11,750
Atlas Iron Works
Saint Louis, MO
2 inspections $11,750
Tenac INC
Morrison, TN
2 inspections $11,750
Grand Rapids Plastics
Grand Rapids, MI
2 inspections $11,750
R & D Tool & Engineering Company
Lees Summit, MO
2 inspections $11,750

Compare Great Dane Limited Partnership vs Hydrite Chemical Company side-by-side →

What to do with this record

Use Great Dane Limited Partnership's enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Great Dane Limited Partnership against Hydrite Chemical Company, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Great Dane Limited Partnership's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Great Dane Limited Partnership safe to work at? ▼
Based on OSHA records, Great Dane Limited Partnership's workplace safety record is relatively clean, with fewer violations than typical. The employer has 4 violations across 4 inspections, including 2 serious violations. Compared to Manufacturing industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does Great Dane Limited Partnership have? ▼
Great Dane Limited Partnership has 4 OSHA violations on record, including 2 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $11,750.
How many OSHA inspections has Great Dane Limited Partnership had? ▼
Great Dane Limited Partnership has had 4 OSHA inspections, with the first recorded on 2011-06-23 and the most recent on 2015-04-23. This averages 1.0 violations per inspection.
What is the total penalty amount for Great Dane Limited Partnership? ▼
Great Dane Limited Partnership has been assessed $11,750 in current OSHA penalties, reduced from an initial assessment of $19,250 (a 39.0% reduction).
Does Great Dane Limited Partnership have any serious or willful violations? ▼
Yes. Great Dane Limited Partnership has 2 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does Great Dane Limited Partnership operate in? ▼
Great Dane Limited Partnership operates in the Manufacturing sector (NAICS code 336212). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.
Where does Great Dane Limited Partnership rank nationally on OSHA penalties? ▼
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Great Dane Limited Partnership ranks #30,567 (the upper half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does Great Dane Limited Partnership's safety record compare to industry average? ▼
Great Dane Limited Partnership's total OSHA penalty of $11,750 is below the Manufacturing industry average of $15,763 per employer. The employer has 4 inspections compared to the industry average of 2.6 per employer. For a direct comparison, R & D Tool & Engineering Company in Lees Summit, MO is a similar manufacturing employer with $11,750 in current penalties.
Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 4 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.