Construction · El Paso, TX

Gil Systems

According to OSHA enforcement records (2010–2026), Gil Systems ranks #34,674 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 7 violations across 4 inspections.

Upper half by penalty71% serious

Compiled by Plainworker · September 6, 2026

$10,060
OSHA penalties: 7
Violations cited: 4
OSHA inspections: #34,674
of 99,447 penalized employers

Gil Systems in El Paso, TX has been the subject of 4 OSHA workplace inspections and 7 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $10,060. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Gil Systems 4 times over 4 years, roughly annually. These inspections resulted in 7 violations, averaging 1.8 per inspection. According to OSHA enforcement records, its total current penalty ranks #34,674 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 5 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this runs moderately above peers (2.0x the sector average) on inspection frequency. For comparison, Seguindo Hauscar Pichasaca in Edison, NJ is another construction employer with 2 OSHA inspections on record and $10,060 in current penalties.

1.8
violations per inspection: 71.4%
of violations were serious: #34,674
of 99,447 penalized employers

Compliance score

C 65/100

C OSHA safety compliance: 7 violations across 4 OSHA inspections (1.8 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Gil Systems

$10,060
Construction avg

$6,767

What this shows Gil Systems runs moderately above peers (1.5x the sector average) in total OSHA penalties.

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$10,060 Bottom 35% least affordable more affordable than 35% of 99,447 U.S. employers with a penalty

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Gil Systems.

Gil Systems has 4 OSHA inspections on record and 7 violations cited. The crosshair marks the median among these Construction peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Gil Systems in the Construction enforcement ledger

Among 33,222 Construction employers with OSHA penalties on file, Gil Systems ranks #9,577 at $10,060 current penalty.

How Gil Systems Compares

Gil Systems's 1.75 violations per inspection compares to the Construction sector average of 3.3 violations per employer.

Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty runs moderately above peers (1.5x the sector average).

Total Inspections

First Inspection

2012-03-05

Last Inspection

2016-05-30

Inspection Span

4 yrs

Violations / Inspection

1.8

Avg Penalty / Inspection

$2,515

Industry Avg / Inspection

$3,361

What this shows 4 inspections over 4 years, averaging 1.8 violations per visit. That's $2,515 per inspection vs. the Construction average of $3,361.

Serious

71.4% of total

Willful

0.0% of total

Repeat

28.6% of total

Other-Than-Serious

0.0% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Initial Penalty Assessed

$23,391

Current Penalty Amount

$10,060

Penalty Reduction

57.0%

What this shows Penalties were reduced by $13,331 from the initial assessment of $23,391. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Construction

How Gil Systems compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.

Metric	Gil Systems	Industry Avg
Inspections	4	2.0
Violations	7	3.3
Total Penalty	$10,060	$6,767
Avg Penalty per Inspection	$2,515	$3,361

View all 61,260 employers in Construction →

Nationwide Construction peers with similar penalties or inspection counts

Two OSHA-record peer sets for Gil Systems, both outside TX so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($10,060 here).

Seguindo Hauscar Pichasaca $10,060 NJ Galicia Construction CO, INC. $10,060 CT American Allstar Home Improvement $10,061 NY Elvis General Construction LLC $10,059 MD

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (4 inspections here).

Bless Construction, INC. 4 insp. Cooper City, FL MR. Roofer, LLC. 4 insp. Charleston, WV Mercado Construction LLC 4 insp. Hagerstown, MD Brick Township Department of Public Works 4 insp. Brick, NJ

Nearby & Similar Employers in Construction

Showing 5 of 61259 other employers tracked in this sector.

Seguindo Hauscar Pichasaca

Edison, NJ

2 inspections $10,060

Galicia Construction CO, INC.

Brookfield, CT

2 inspections $10,060

American Allstar Home Improvement

Buffalo, NY

2 inspections $10,061

Prime J Roofing

San Antonio, TX

2 inspections $10,059

Elvis General Construction LLC

Westminster, MD

3 inspections $10,059

Compare Gil Systems vs Seguindo Hauscar Pichasaca side-by-side →

What to do with this record

Use Gil Systems's enforcement history as one data point, not the whole picture.

A single employer's record can look unusual in isolation. Compare Gil Systems against Seguindo Hauscar Pichasaca, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
See whether Gil Systems's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Gil Systems safe to work at? ▼

Based on OSHA records, Gil Systems's workplace safety record is concerning, with multiple serious compliance issues. The employer has 7 violations across 4 inspections, including 5 serious violations. Compared to Construction industry peers, this is above average for penalties. Review the full inspection history below for details.

How many OSHA violations does Gil Systems have? ▼

Gil Systems has 7 OSHA violations on record, including 5 serious, 0 willful, and 2 repeat violations. The total current penalty amount is $10,060.

How many OSHA inspections has Gil Systems had? ▼

Gil Systems has had 4 OSHA inspections, with the first recorded on 2012-03-05 and the most recent on 2016-05-30. This averages 1.8 violations per inspection.

What is the total penalty amount for Gil Systems? ▼

Gil Systems has been assessed $10,060 in current OSHA penalties, reduced from an initial assessment of $23,391 (a 57.0% reduction).

Does Gil Systems have any serious or willful violations? ▼

Yes. Gil Systems has 5 serious violations, and 2 repeat violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.

What industry does Gil Systems operate in? ▼

Gil Systems operates in the Construction sector (NAICS code 238160). This industry has 61,260 employers tracked by PlainWorker, with 123,354 total OSHA inspections and $414.57M in cumulative penalties.

Where does Gil Systems rank nationally on OSHA penalties? ▼

Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Gil Systems ranks #34,674 (the upper half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.

How does Gil Systems's safety record compare to industry average? ▼

Gil Systems's total OSHA penalty of $10,060 is above the Construction industry average of $6,767 per employer (1.5x the average). The employer has 4 inspections compared to the industry average of 2.0 per employer. For a direct comparison, Seguindo Hauscar Pichasaca in Edison, NJ is a similar construction employer with $10,060 in current penalties.

Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.