Manufacturing · Anniston, AL
General Dynamics Land Systems, INC.
According to OSHA enforcement records (2010–2026), General Dynamics Land Systems, INC. ranks #65,697 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 2 violations across 2 inspections.
- $3,366
- OSHA penalties
- 2
- Violations cited
- 2
- OSHA inspections
- #65,697
- of 99,447 penalized employers
General Dynamics Land Systems, INC. in Anniston, AL has been the subject of 2 OSHA workplace inspections and 2 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $3,366. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected General Dynamics Land Systems, INC. 2 times over 2 years, roughly annually. These inspections resulted in 2 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #65,697 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs moderately below peers (0.8x the sector average) on inspection frequency. For comparison, Protech Metal Finishing LLC in Vonore, TN is another manufacturing employer with 2 OSHA inspections on record and $3,363 in current penalties.
- 1.0
- violations per inspection
- 100.0%
- of violations were serious
- #65,697
- of 99,447 penalized employers
Compliance score
- C OSHA safety compliance: 2 violations across 2 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How this employer compares on OSHA penalties
Total current penalty vs the Manufacturing per-employer average
- General Dynamics Land … $3,366
General Dynamics Land Systems, INC.
$3,366 in penalties
- Manufacturing avg
Manufacturing industry average (per employer)
$15,763 in penalties
What this shows General Dynamics Land Systems, INC. runs well below peers (0.21x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$3,366 Top 34% most affordable more affordable than 66% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is General Dynamics Land Systems, INC..
General Dynamics Land Systems, INC. in the Manufacturing enforcement ledger
In Manufacturing, General Dynamics Land Systems, INC. sits at penalty rank #26,486 of 35,243 penalized establishments ($3,366 assessed).
How General Dynamics Land Systems, INC. Compares
General Dynamics Land Systems, INC.'s 1.00 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.
Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs well below peers (0.21x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2014-07-18
Last Inspection
2016-10-11
Inspection Span
2 yrs
Violations / Inspection
1.0
Avg Penalty / Inspection
$1,683
Industry Avg / Inspection
$6,093
What this shows 2 inspections over 2 years, averaging 1.0 violations per visit. That's $1,683 per inspection vs. the Manufacturing average of $6,093.
Enforcement detail
Violation Breakdown
2
Serious
100.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
0
Other-Than-Serious
0.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$14,844
Current Penalty Amount
$3,366
Penalty Reduction
77.3%
What this shows Penalties were reduced by $11,478 from the initial assessment of $14,844. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Manufacturing
How General Dynamics Land Systems, INC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.
| Metric | General Dynamics Land Systems, INC. | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.6 |
| Violations | 2 | 8.0 |
| Total Penalty | $3,366 | $15,763 |
| Avg Penalty per Inspection | $1,683 | $6,093 |
Nationwide Manufacturing peers with similar penalties or inspection counts
Two OSHA-record peer sets for General Dynamics Land Systems, INC., both outside AL so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($3,366 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Manufacturing
Showing 5 of 44644 other employers tracked in this sector.
Compare General Dynamics Land Systems, INC. vs American Dryer Corporation side-by-side →
What to do with this record
Use General Dynamics Land Systems, INC.'s enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare General Dynamics Land Systems, INC. against American Dryer Corporation, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether General Dynamics Land Systems, INC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is General Dynamics Land Systems, INC. safe to work at? ▼
How many OSHA violations does General Dynamics Land Systems, INC. have? ▼
How many OSHA inspections has General Dynamics Land Systems, INC. had? ▼
What is the total penalty amount for General Dynamics Land Systems, INC.? ▼
Does General Dynamics Land Systems, INC. have any serious or willful violations? ▼
What industry does General Dynamics Land Systems, INC. operate in? ▼
Where does General Dynamics Land Systems, INC. rank nationally on OSHA penalties? ▼
How does General Dynamics Land Systems, INC.'s safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.