Manufacturing · Macon, GA
Diamond Plastics Corporation
According to OSHA enforcement records (2010–2026), Diamond Plastics Corporation ranks #5,899 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 13 violations across 6 inspections.
- $45,105
- OSHA penalties
- 13
- Violations cited
- 6
- OSHA inspections
- #5,899
- of 99,447 penalized employers
Diamond Plastics Corporation in Macon, GA has been the subject of 6 OSHA workplace inspections and 13 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $45,105. Federal wage-and-hour enforcement records also show 0 WHD violations against this employer under the Fair Labor Standards Act. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Diamond Plastics Corporation 6 times over 12 years, roughly once every couple of years. These inspections resulted in 13 violations, averaging 2.2 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #5,899 of 99,447 penalized U.S. employers (the top 10% of penalized employers nationally). Of these, 6 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this runs well above peers (2.3x the sector average) on inspection frequency. The Department of Labor also found wage violations, with $0 in back wages owed to an undisclosed number of workers. For comparison, Saipan Ice & Water Co Inc. in Saipan, MP is another manufacturing employer with 0 OSHA inspections on record and $0 in current penalties.
- 2.2
- violations per inspection
- 46.2%
- of violations were serious
- #5,899
- of 99,447 penalized employers
- $0
- in back wages recovered
Compliance score
- D OSHA safety compliance: 13 violations across 6 OSHA inspections (2.2 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
- A Wage & hour compliance: $0 in back wages owed across 1 WHD case ($0 per case), vs. national p10 $2K (best) / p90 $58K (worst) among 91,622 employers with a WHD case on file.
How Diamond Plastics Corporation compares on OSHA penalties
Total current penalty vs the Manufacturing per-employer average
- Diamond Plastics Corpo…
Diamond Plastics Corporation
$45,105 in penalties
- Manufacturing avg $15,763
Manufacturing industry average (per employer)
$15,763 in penalties
What this shows Diamond Plastics Corporation runs well above peers (2.9x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$45,105 Bottom 6% least affordable more affordable than 6% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Diamond Plastics Corporation.
Diamond Plastics Corporation in the Manufacturing enforcement ledger
Among 35,243 Manufacturing employers with OSHA penalties on file, Diamond Plastics Corporation ranks #2,981 at $45,105 current penalty.
Combined federal exposure here: $45,105 OSHA penalties plus $0 WHD back wages (0.0% of the combined total is wage recovery).
How Diamond Plastics Corporation Compares
Diamond Plastics Corporation's 2.17 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.
Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs well above peers (2.9x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
6
First Inspection
2012-08-09
Last Inspection
2024-11-15
Inspection Span
12 yrs
Violations / Inspection
2.2
Avg Penalty / Inspection
$7,518
Industry Avg / Inspection
$6,093
What this shows 6 inspections over 12 years, averaging 2.2 violations per visit. That's $7,518 per inspection vs. the Manufacturing average of $6,093.
Enforcement detail
Violation Breakdown
6
Serious
46.2% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
7
Other-Than-Serious
53.8% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$69,753
Current Penalty Amount
$45,105
Penalty Reduction
35.3%
Combined Impact (OSHA + WHD)
$45,105
What this shows Penalties were reduced by $24,648 from the initial assessment of $69,753. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Wage & Hour Findings
Industry Safety Context: Manufacturing
How Diamond Plastics Corporation compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.
| Metric | Diamond Plastics Corporation | Industry Avg |
|---|---|---|
| Inspections | 6 | 2.6 |
| Violations | 13 | 8.0 |
| Total Penalty | $45,105 | $15,763 |
| Avg Penalty per Inspection | $7,518 | $6,093 |
Nationwide Manufacturing peers with similar penalties or inspection counts
Two OSHA-record peer sets for Diamond Plastics Corporation, both outside GA so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($45,105 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (6 inspections here).
Nearby & Similar Employers in Manufacturing
Showing 5 of 44644 other employers tracked in this sector.
Compare Diamond Plastics Corporation vs U.S. Zinc Corporation side-by-side →
What to do with this record
Use Diamond Plastics Corporation's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Diamond Plastics Corporation against U.S. Zinc Corporation, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Diamond Plastics Corporation's inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
- Diamond Plastics Corporation also carries $0 in Wage and Hour Division back-wages, a separate enforcement track from OSHA safety violations. How wage-theft enforcement works
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Diamond Plastics Corporation safe to work at? ▼
How many OSHA violations does Diamond Plastics Corporation have? ▼
How many OSHA inspections has Diamond Plastics Corporation had? ▼
What is the total penalty amount for Diamond Plastics Corporation? ▼
Does Diamond Plastics Corporation have any serious or willful violations? ▼
Has Diamond Plastics Corporation been cited for wage theft? ▼
What industry does Diamond Plastics Corporation operate in? ▼
What should I do if Diamond Plastics Corporation owes me wages? ▼
Where does Diamond Plastics Corporation rank nationally on OSHA penalties? ▼
How does Diamond Plastics Corporation's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.