Construction · Tucson, AZ

Cutting Edge Fabrication, L.L.C.

According to OSHA enforcement records (2010–2026), Cutting Edge Fabrication, L.L.C. ranks #30,567 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 11 violations across 7 inspections.

Upper half by penalty45% serious

Compiled by Plainworker · September 6, 2026

$11,750
OSHA penalties: 11
Violations cited: 7
OSHA inspections: #30,567
of 99,447 penalized employers

Cutting Edge Fabrication, L.L.C. in Tucson, AZ has been the subject of 7 OSHA workplace inspections and 11 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $11,750. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Cutting Edge Fabrication, L.L.C. 7 times over 9 years, roughly once every couple of years. These inspections resulted in 11 violations, averaging 1.6 per inspection. According to OSHA enforcement records, its total current penalty ranks #30,567 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 5 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this runs well above peers (3.5x the sector average) on inspection frequency. For comparison, Atlas Developers LLC in Brooklyn, NY is another construction employer with 3 OSHA inspections on record and $11,750 in current penalties.

1.6
violations per inspection: 45.5%
of violations were serious: #30,567
of 99,447 penalized employers

Compliance score

C 67/100

C OSHA safety compliance: 11 violations across 7 OSHA inspections (1.6 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

Cutting Edge Fabricati…

$11,750
Construction avg

$6,767

What this shows Cutting Edge Fabrication, L.L.C. runs moderately above peers (1.7x the sector average) in total OSHA penalties.

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$11,750 Bottom 31% least affordable more affordable than 31% of 99,447 U.S. employers with a penalty

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Cutting Edge Fabrication, L.L.C..

Cutting Edge Fabrication, L.L.C. has 7 OSHA inspections on record and 11 violations cited. The crosshair marks the median among these Construction peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Cutting Edge Fabrication, L.L.C. in the Construction enforcement ledger

Among 33,222 Construction employers with OSHA penalties on file, Cutting Edge Fabrication, L.L.C. ranks #8,218 at $11,750 current penalty.

How Cutting Edge Fabrication, L.L.C. Compares

Cutting Edge Fabrication, L.L.C.'s 1.57 violations per inspection compares to the Construction sector average of 3.3 violations per employer.

Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty runs moderately above peers (1.7x the sector average).

Total Inspections

First Inspection

2010-02-15

Last Inspection

2019-01-25

Inspection Span

9 yrs

Violations / Inspection

1.6

Avg Penalty / Inspection

$1,679

Industry Avg / Inspection

$3,361

What this shows 7 inspections over 9 years, averaging 1.6 violations per visit. That's $1,679 per inspection vs. the Construction average of $3,361.

Serious

45.5% of total

Willful

0.0% of total

Repeat

0.0% of total

Other-Than-Serious

54.5% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Initial Penalty Assessed

$14,000

Current Penalty Amount

$11,750

Penalty Reduction

16.1%

What this shows Penalties were reduced by $2,250 from the initial assessment of $14,000. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Construction

How Cutting Edge Fabrication, L.L.C. compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.

Metric	Cutting Edge Fabrication, L.L.C.	Industry Avg
Inspections	7	2.0
Violations	11	3.3
Total Penalty	$11,750	$6,767
Avg Penalty per Inspection	$1,679	$3,361

View all 61,260 employers in Construction →

Nationwide Construction peers with similar penalties or inspection counts

Two OSHA-record peer sets for Cutting Edge Fabrication, L.L.C., both outside AZ so the neighborhoods are not geographic containment.

Similar current OSHA penalty

Nearest same-sector employers by current assessed penalty ($11,750 here).

KBS INC $11,750 VA Vortex Construction $11,750 CA Atlas Developers LLC $11,750 NY Migel Cruz $11,750 KY

Similar OSHA inspection count

Same-sector employers with a comparable inspection history outside this state (7 inspections here).

Dondlinger & Sons Construction CO., INC. 7 insp. Wichita, KS Unknown/Invalid Establishment 7 insp. Reno, NV Preble TN HWY Dept 7 insp. Preble, NY Edwards TN HWY Dept 7 insp. Edwards, NY

Nearby & Similar Employers in Construction

Showing 5 of 61259 other employers tracked in this sector.

KBS INC

Richmond, VA

10 inspections $11,750

Vortex Construction

Goleta, CA

2 inspections $11,750

Atlas Developers LLC

Brooklyn, NY

3 inspections $11,750

Migel Cruz

New Haven, KY

2 inspections $11,750

MSS Enterprises

Severn, MD

0 inspections $0

Compare Cutting Edge Fabrication, L.L.C. vs KBS INC side-by-side →

What to do with this record

Use Cutting Edge Fabrication, L.L.C.'s enforcement history as one data point, not the whole picture.

A single employer's record can look unusual in isolation. Compare Cutting Edge Fabrication, L.L.C. against KBS INC, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
See whether Cutting Edge Fabrication, L.L.C.'s inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Cutting Edge Fabrication, L.L.C. safe to work at? ▼

Based on OSHA records, Cutting Edge Fabrication, L.L.C.'s workplace safety record is mixed, with some compliance concerns. The employer has 11 violations across 7 inspections, including 5 serious violations. Compared to Construction industry peers, this is above average for penalties. Review the full inspection history below for details.

How many OSHA violations does Cutting Edge Fabrication, L.L.C. have? ▼

Cutting Edge Fabrication, L.L.C. has 11 OSHA violations on record, including 5 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $11,750.

How many OSHA inspections has Cutting Edge Fabrication, L.L.C. had? ▼

Cutting Edge Fabrication, L.L.C. has had 7 OSHA inspections, with the first recorded on 2010-02-15 and the most recent on 2019-01-25. This averages 1.6 violations per inspection.

What is the total penalty amount for Cutting Edge Fabrication, L.L.C.? ▼

Cutting Edge Fabrication, L.L.C. has been assessed $11,750 in current OSHA penalties, reduced from an initial assessment of $14,000 (a 16.1% reduction).

Does Cutting Edge Fabrication, L.L.C. have any serious or willful violations? ▼

Yes. Cutting Edge Fabrication, L.L.C. has 5 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.

What industry does Cutting Edge Fabrication, L.L.C. operate in? ▼

Cutting Edge Fabrication, L.L.C. operates in the Construction sector (NAICS code 238120). This industry has 61,260 employers tracked by PlainWorker, with 123,354 total OSHA inspections and $414.57M in cumulative penalties.

Where does Cutting Edge Fabrication, L.L.C. rank nationally on OSHA penalties? ▼

Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Cutting Edge Fabrication, L.L.C. ranks #30,567 (the upper half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.

How does Cutting Edge Fabrication, L.L.C.'s safety record compare to industry average? ▼

Cutting Edge Fabrication, L.L.C.'s total OSHA penalty of $11,750 is above the Construction industry average of $6,767 per employer (1.7x the average). The employer has 7 inspections compared to the industry average of 2.0 per employer. For a direct comparison, Atlas Developers LLC in Brooklyn, NY is a similar construction employer with $11,750 in current penalties.

Data Sources & Methodology ▼

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.