Manufacturing · Oshkosh, WI

Crown Cork & Seal USA, INC.

According to OSHA enforcement records (2010–2026), Crown Cork & Seal USA, INC. ranks #65,563 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 3 violations across 3 inspections.

Lower half by penalty67% serious
$3,400
OSHA penalties
3
Violations cited
3
OSHA inspections
#65,563
of 99,447 penalized employers

Crown Cork & Seal USA, INC. in Oshkosh, WI has been the subject of 3 OSHA workplace inspections and 3 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $3,400. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.

The record in one line

OSHA has inspected Crown Cork & Seal USA, INC. 3 times over 2 years, roughly annually. These inspections resulted in 3 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #65,563 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 2 were classified as serious - indicating hazards that could cause death or serious harm. Against the Manufacturing industry average of 3 inspections per employer, this sits roughly in line with peers (1.2x the sector average) on inspection frequency. For comparison, Multimetal INC. in Greensburg, PA is another manufacturing employer with 2 OSHA inspections on record and $3,400 in current penalties.

1.0
violations per inspection
66.7%
of violations were serious
#65,563
of 99,447 penalized employers

Compliance score

C 75/100
  • C OSHA safety compliance: 3 violations across 3 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.

Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.

Open my watchlist

How Crown Cork & Seal USA, INC. compares on OSHA penalties

Total current penalty vs the Manufacturing per-employer average

in penalties

What this shows Crown Cork & Seal USA, INC. runs well below peers (0.22x the sector average) in total OSHA penalties.

Source U.S. Department of Labor, OSHA enforcement extracts As of 2026

Where this penalty ranks nationally

Total current OSHA penalty vs every U.S. employer with a nonzero penalty

$3,400 Top 34% most affordable more affordable than 66% of 99,447 U.S. employers with a penalty

$0–$5,000: 43,959 U.S. employers with a penalty (44%). This entry sits in this band. $5,000–$10,000: 20,304 U.S. employers with a penalty (20%). Above this entry. $10,000–$15,000: 11,027 U.S. employers with a penalty (11%). Above this entry. $15,000–$20,000: 6,546 U.S. employers with a penalty (7%). Above this entry. $20,000–$25,000: 4,175 U.S. employers with a penalty (4%). Above this entry. $25,000–$30,000: 2,877 U.S. employers with a penalty (3%). Above this entry. $30,000–$35,000: 2,036 U.S. employers with a penalty (2%). Above this entry. $35,000–$40,000: 1,493 U.S. employers with a penalty (2%). Above this entry. $40,000–$45,000: 1,095 U.S. employers with a penalty (1%). Above this entry. $45,000–$50,000: 785 U.S. employers with a penalty (1%). Above this entry. $50,000–$55,000: 5,150 U.S. employers with a penalty (5%). Above this entry. This employer $0 $55,000 every penalized U.S. employer, bucketed by value

Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.

Source U.S. Department of Labor, OSHA enforcement extracts · 2026

Does more inspection scrutiny mean more findings?

Each dot is one of 21 Manufacturing employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Crown Cork & Seal USA, INC..

Frequently inspected, many findingsRarely inspected, many findingsFrequently inspected, clean recordBelow median on both3.03.033.03.0014.729.444.058.7OSHA inspectionsViolations citedMARBLE BUILDER DIREC…, OSHA inspections: 3 · Violations cited: 55EAST BALT BAKERIES, OSHA inspections: 3 · Violations cited: 9CJ FOODS MANUFACTURI…, OSHA inspections: 3 · Violations cited: 4TFO TECH CO., LTD, OSHA inspections: 3 · Violations cited: 22CARONE & COMPANY, INC., OSHA inspections: 3 · Violations cited: 4GREENCORE USA, INC., OSHA inspections: 3 · Violations cited: 21SAFETY STORAGE, INC., OSHA inspections: 3 · Violations cited: 8WYRMWOOD, INC., OSHA inspections: 3 · Violations cited: 10FIRST STRING SPACE, …, OSHA inspections: 3 · Violations cited: 25GEM STATE PROCESSING…, OSHA inspections: 3 · Violations cited: 6GREDE II LLC, OSHA inspections: 3 · Violations cited: 37B&H MILLWORK & FIXTU…, OSHA inspections: 3 · Violations cited: 56JONES LUMBER GLOSTER…, OSHA inspections: 3 · Violations cited: 8NAILOR INDUSTRIES OF…, OSHA inspections: 3 · Violations cited: 5VANDIVER STEEL FABRI…, OSHA inspections: 3 · Violations cited: 28RD HENRY & COMPANY LLC, OSHA inspections: 3 · Violations cited: 8SPRING CITY ELECTRIC…, OSHA inspections: 3 · Violations cited: 5CONNECTICUT STONE SU…, OSHA inspections: 3 · Violations cited: 42HAMBURG FINISHING WO…, OSHA inspections: 3 · Violations cited: 6NORTHROP GRUMMAN SYS…, OSHA inspections: 3 · Violations cited: 2Crown Cork & Seal US…, OSHA inspections: 3 · Violations cited: 3
Crown Cork & Seal USA, INC. has 3 OSHA inspections on record and 3 violations cited. The crosshair marks the median among these Manufacturing peers. Across this sector's tracked employers, more inspections is moderately associated with more violations found -- not a coincidence, but not a guarantee either.

Crown Cork & Seal USA, INC. in the Manufacturing enforcement ledger

In Manufacturing, Crown Cork & Seal USA, INC. sits at penalty rank #26,403 of 35,243 penalized establishments ($3,400 assessed).

How Crown Cork & Seal USA, INC. Compares

Crown Cork & Seal USA, INC.'s 1.00 violations per inspection compares to the Manufacturing sector average of 8.0 violations per employer.

Against the Manufacturing industry average of $15,763 per employer, this employer's current OSHA penalty runs well below peers (0.22x the sector average).

Enforcement detail

OSHA Inspection History

Total Inspections

3

First Inspection

2012-03-23

Last Inspection

2014-01-22

Inspection Span

2 yrs

Violations / Inspection

1.0

Avg Penalty / Inspection

$1,133

Industry Avg / Inspection

$6,093

What this shows 3 inspections over 2 years, averaging 1.0 violations per visit. That's $1,133 per inspection vs. the Manufacturing average of $6,093.

Enforcement detail

Violation Breakdown

2

Serious

66.7% of total

0

Willful

0.0% of total

0

Repeat

0.0% of total

1

Other-Than-Serious

33.3% of total

What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.

Enforcement detail

Penalty Analysis

Initial Penalty Assessed

$7,650

Current Penalty Amount

$3,400

Penalty Reduction

55.6%

What this shows Penalties were reduced by $4,250 from the initial assessment of $7,650. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.

Industry Safety Context: Manufacturing

How Crown Cork & Seal USA, INC. compares to the Manufacturing sector, which has 44,645 employers tracked by PlainWorker.

Metric Crown Cork & Seal USA, INC. Industry Avg
Inspections 3 2.6
Violations 3 8.0
Total Penalty $3,400 $15,763
Avg Penalty per Inspection $1,133 $6,093

Nationwide Manufacturing peers with similar penalties or inspection counts

Two OSHA-record peer sets for Crown Cork & Seal USA, INC., both outside WI so the neighborhoods are not geographic containment.

Nearby & Similar Employers in Manufacturing

Showing 5 of 44644 other employers tracked in this sector.

Compare Crown Cork & Seal USA, INC. vs Multimetal INC. side-by-side →

What to do with this record

Use Crown Cork & Seal USA, INC.'s enforcement history as one data point, not the whole picture.

  • A single employer's record can look unusual in isolation. Compare Crown Cork & Seal USA, INC. against Multimetal INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
  • See whether Crown Cork & Seal USA, INC.'s inspection and penalty record is typical for Manufacturing or an outlier against the sector's own average. View the Manufacturing sector
  • Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers

Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.

Frequently Asked Questions

Is Crown Cork & Seal USA, INC. safe to work at?
Based on OSHA records, Crown Cork & Seal USA, INC.'s workplace safety record is relatively clean, with fewer violations than typical. The employer has 3 violations across 3 inspections, including 2 serious violations. Compared to Manufacturing industry peers, this is below average for penalties. Review the full inspection history below for details.
How many OSHA violations does Crown Cork & Seal USA, INC. have?
Crown Cork & Seal USA, INC. has 3 OSHA violations on record, including 2 serious, 0 willful, and 0 repeat violations. The total current penalty amount is $3,400.
How many OSHA inspections has Crown Cork & Seal USA, INC. had?
Crown Cork & Seal USA, INC. has had 3 OSHA inspections, with the first recorded on 2012-03-23 and the most recent on 2014-01-22. This averages 1.0 violations per inspection.
What is the total penalty amount for Crown Cork & Seal USA, INC.?
Crown Cork & Seal USA, INC. has been assessed $3,400 in current OSHA penalties, reduced from an initial assessment of $7,650 (a 55.6% reduction).
Does Crown Cork & Seal USA, INC. have any serious or willful violations?
Yes. Crown Cork & Seal USA, INC. has 2 serious violations. Serious violations involve hazards likely to cause death or serious physical harm. Willful violations indicate the employer intentionally or knowingly disregarded the law.
What industry does Crown Cork & Seal USA, INC. operate in?
Crown Cork & Seal USA, INC. operates in the Manufacturing sector (NAICS code 332431). This industry has 44,645 employers tracked by PlainWorker, with 115,492 total OSHA inspections and $703.72M in cumulative penalties.
Where does Crown Cork & Seal USA, INC. rank nationally on OSHA penalties?
Among the 99,447 U.S. employers with a nonzero current OSHA penalty in PlainWorker's corpus, Crown Cork & Seal USA, INC. ranks #65,563 (the lower half of penalized employers nationally). The ordinal is a live COUNT of employers with a lower total_current_penalty; see the methodology page for the exact derivation.
How does Crown Cork & Seal USA, INC.'s safety record compare to industry average?
Crown Cork & Seal USA, INC.'s total OSHA penalty of $3,400 is below the Manufacturing industry average of $15,763 per employer. The employer has 3 inspections compared to the industry average of 2.6 per employer. For a direct comparison, Multimetal INC. in Greensburg, PA is a similar manufacturing employer with $3,400 in current penalties.
Data Sources & Methodology

Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).

Source: OSHA Enforcement Data

Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.

Source: Wage and Hour Division (WHD)

Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.

Employer Matching

Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.

Verify with OSHA establishment search →

Every figure on PlainWorker is rendered directly from official U.S. Department of Labor OSHA and Wage & Hour Division enforcement records, no number is typed in by an editor. This employer's ratios (penalty-per-violation, industry comparisons) are computed live from the 3 inspections on record. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error. Data current as of 2026.