Retail Trade · Oklahoma City, OK
C & C Used Auto Parts
According to OSHA enforcement records (2010–2026), C & C Used Auto Parts ranks #84,567 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 2 violations across 2 inspections.
- $1,200
- OSHA penalties
- 2
- Violations cited
- 2
- OSHA inspections
- #84,567
- of 99,447 penalized employers
C & C Used Auto Parts in Oklahoma City, OK has been the subject of 2 OSHA workplace inspections and 2 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $1,200. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected C & C Used Auto Parts 2 times over 4 years, roughly once every couple of years. These inspections resulted in 2 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #84,567 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 1 were classified as serious - indicating hazards that could cause death or serious harm. Against the Retail Trade industry average of 1 inspections per employer, this runs well above peers (2.5x the sector average) on inspection frequency. For comparison, Lipscomb Oil Company in Greenville, MS is another retail trade employer with 2 OSHA inspections on record and $1,200 in current penalties.
- 1.0
- violations per inspection
- 50.0%
- of violations were serious
- #84,567
- of 99,447 penalized employers
Compliance score
- C OSHA safety compliance: 2 violations across 2 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How C & C Used Auto Parts compares on OSHA penalties
Total current penalty vs the Retail Trade per-employer average
- C & C Used Auto Parts
C & C Used Auto Parts
$1,200 in penalties
- Retail Trade avg
Retail Trade industry average (per employer)
$2,898 in penalties
What this shows C & C Used Auto Parts runs moderately below peers (0.4x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$1,200 Top 15% most affordable more affordable than 85% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Retail Trade employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is C & C Used Auto Parts.
C & C Used Auto Parts in the Retail Trade enforcement ledger
Retail Trade sector: C & C Used Auto Parts is the #2,447 heaviest OSHA penalty carrier of 3,175 employers with nonzero fines ($1,200).
How C & C Used Auto Parts Compares
C & C Used Auto Parts's 1.00 violations per inspection compares to the Retail Trade sector average of 1.7 violations per employer.
Against the Retail Trade industry average of $2,898 per employer, this employer's current OSHA penalty runs moderately below peers (0.4x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2013-04-04
Last Inspection
2017-01-19
Inspection Span
4 yrs
Violations / Inspection
1.0
Avg Penalty / Inspection
$600
Industry Avg / Inspection
$3,571
What this shows 2 inspections over 4 years, averaging 1.0 violations per visit. That's $600 per inspection vs. the Retail Trade average of $3,571.
Enforcement detail
Violation Breakdown
1
Serious
50.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
1
Other-Than-Serious
50.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$2,000
Current Penalty Amount
$1,200
Penalty Reduction
40.0%
What this shows Penalties were reduced by $800 from the initial assessment of $2,000. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Retail Trade
How C & C Used Auto Parts compares to the Retail Trade sector, which has 12,945 employers tracked by PlainWorker.
| Metric | C & C Used Auto Parts | Industry Avg |
|---|---|---|
| Inspections | 2 | 0.8 |
| Violations | 2 | 1.7 |
| Total Penalty | $1,200 | $2,898 |
| Avg Penalty per Inspection | $600 | $3,571 |
Nationwide Retail Trade peers with similar penalties or inspection counts
Two OSHA-record peer sets for C & C Used Auto Parts, both outside OK so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($1,200 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Retail Trade
Showing 5 of 12944 other employers tracked in this sector.
Compare C & C Used Auto Parts vs Goodwill Industries side-by-side →
What to do with this record
Use C & C Used Auto Parts's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare C & C Used Auto Parts against Goodwill Industries, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether C & C Used Auto Parts's inspection and penalty record is typical for Retail Trade or an outlier against the sector's own average. View the Retail Trade sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is C & C Used Auto Parts safe to work at? ▼
How many OSHA violations does C & C Used Auto Parts have? ▼
How many OSHA inspections has C & C Used Auto Parts had? ▼
What is the total penalty amount for C & C Used Auto Parts? ▼
Does C & C Used Auto Parts have any serious or willful violations? ▼
What industry does C & C Used Auto Parts operate in? ▼
Where does C & C Used Auto Parts rank nationally on OSHA penalties? ▼
How does C & C Used Auto Parts's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.