Wholesale Trade · Eckhart Mines, MD
Bill Miller Equipment Sales, INC.
According to OSHA enforcement records (2010–2026), Bill Miller Equipment Sales, INC. ranks #84,854 of 99,447 penalized U.S. employers by total current penalty, with a concerning safety record: 10 violations across 2 inspections.
- $1,147
- OSHA penalties
- 10
- Violations cited
- 2
- OSHA inspections
- #84,854
- of 99,447 penalized employers
Bill Miller Equipment Sales, INC. in Eckhart Mines, MD has been the subject of 2 OSHA workplace inspections and 10 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $1,147. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Bill Miller Equipment Sales, INC. 2 times over 1 year - more than twice a year on average. These inspections resulted in 10 violations, averaging 5.0 per inspection - a notably high rate. According to OSHA enforcement records, its total current penalty ranks #84,854 of 99,447 penalized U.S. employers (the lower half of penalized employers nationally). Of these, 3 were classified as serious - indicating hazards that could cause death or serious harm. Against the Wholesale Trade industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Keystone Automotive Industries, Inc. in Theodore, AL is another wholesale trade employer with 0 OSHA inspections on record and $0 in current penalties.
- 5.0
- violations per inspection
- 30.0%
- of violations were serious
- #84,854
- of 99,447 penalized employers
Compliance score
- F OSHA safety compliance: 10 violations across 2 OSHA inspections (5.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How this employer compares on OSHA penalties
Total current penalty vs the Wholesale Trade per-employer average
- Bill Miller Equipment … $1,147
Bill Miller Equipment Sales, INC.
$1,147 in penalties
- Wholesale Trade avg
Wholesale Trade industry average (per employer)
$9,112 in penalties
What this shows Bill Miller Equipment Sales, INC. runs well below peers (0.13x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$1,147 Top 15% most affordable more affordable than 85% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Wholesale Trade employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Bill Miller Equipment Sales, INC..
Bill Miller Equipment Sales, INC. in the Wholesale Trade enforcement ledger
Among 4,429 Wholesale Trade employers with OSHA penalties on file, Bill Miller Equipment Sales, INC. ranks #3,943 at $1,147 current penalty.
How Bill Miller Equipment Sales, INC. Compares
Bill Miller Equipment Sales, INC.'s 5.00 violations per inspection compares to the Wholesale Trade sector average of 5.5 violations per employer.
Against the Wholesale Trade industry average of $9,112 per employer, this employer's current OSHA penalty runs well below peers (0.13x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2016-04-05
Last Inspection
2016-04-05
Inspection Span
1 yr
Violations / Inspection
5.0
Avg Penalty / Inspection
$574
Industry Avg / Inspection
$4,665
What this shows 2 inspections over 1 year, averaging 5.0 violations per visit. That's $574 per inspection vs. the Wholesale Trade average of $4,665.
Enforcement detail
Violation Breakdown
3
Serious
30.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
7
Other-Than-Serious
70.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$1,687
Current Penalty Amount
$1,147
Penalty Reduction
32.0%
What this shows Penalties were reduced by $540 from the initial assessment of $1,687. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Wholesale Trade
How Bill Miller Equipment Sales, INC. compares to the Wholesale Trade sector, which has 6,881 employers tracked by PlainWorker.
| Metric | Bill Miller Equipment Sales, INC. | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.0 |
| Violations | 10 | 5.5 |
| Total Penalty | $1,147 | $9,112 |
| Avg Penalty per Inspection | $574 | $4,665 |
Nationwide Wholesale Trade peers with similar penalties or inspection counts
Two OSHA-record peer sets for Bill Miller Equipment Sales, INC., both outside MD so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($1,147 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Wholesale Trade
Showing 5 of 6880 other employers tracked in this sector.
Compare Bill Miller Equipment Sales, INC. vs Performance Food Group, INC. side-by-side →
What to do with this record
Use Bill Miller Equipment Sales, INC.'s enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Bill Miller Equipment Sales, INC. against Performance Food Group, INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Bill Miller Equipment Sales, INC.'s inspection and penalty record is typical for Wholesale Trade or an outlier against the sector's own average. View the Wholesale Trade sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Bill Miller Equipment Sales, INC. safe to work at? ▼
How many OSHA violations does Bill Miller Equipment Sales, INC. have? ▼
How many OSHA inspections has Bill Miller Equipment Sales, INC. had? ▼
What is the total penalty amount for Bill Miller Equipment Sales, INC.? ▼
Does Bill Miller Equipment Sales, INC. have any serious or willful violations? ▼
What industry does Bill Miller Equipment Sales, INC. operate in? ▼
Where does Bill Miller Equipment Sales, INC. rank nationally on OSHA penalties? ▼
How does Bill Miller Equipment Sales, INC.'s safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.