Construction · San Francisco, CA
Ashbury General Contracting and Engineering
According to OSHA enforcement records (2010–2026), Ashbury General Contracting and Engineering ranks #49,680 of 99,447 penalized U.S. employers by total current penalty, with a mixed safety record: 9 violations across 3 inspections.
- $6,075
- OSHA penalties
- 9
- Violations cited
- 3
- OSHA inspections
- #49,680
- of 99,447 penalized employers
Ashbury General Contracting and Engineering in San Francisco, CA has been the subject of 3 OSHA workplace inspections and 9 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $6,075. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected Ashbury General Contracting and Engineering 3 times over 6 years, roughly once every couple of years. These inspections resulted in 9 violations, averaging 3.0 per inspection, above what's typical for a single visit. According to OSHA enforcement records, its total current penalty ranks #49,680 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 1 were classified as serious - indicating hazards that could cause death or serious harm. Against the Construction industry average of 2 inspections per employer, this runs moderately above peers (1.5x the sector average) on inspection frequency. For comparison, Eckhardt & Johnson INC. in Manchester, NH is another construction employer with 2 OSHA inspections on record and $6,076 in current penalties.
- 3.0
- violations per inspection
- 11.1%
- of violations were serious
- #49,680
- of 99,447 penalized employers
Compliance score
- F OSHA safety compliance: 9 violations across 3 OSHA inspections (3.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How this employer compares on OSHA penalties
Total current penalty vs the Construction per-employer average
- Ashbury General Contra…
Ashbury General Contracting and Engineering
$6,075 in penalties
- Construction avg
Construction industry average (per employer)
$6,767 in penalties
What this shows Ashbury General Contracting and Engineering sits roughly in line with peers (0.9x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$6,075 Top 50% most affordable more affordable than 50% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Construction employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is Ashbury General Contracting and Engineering.
Ashbury General Contracting and Engineering in the Construction enforcement ledger
In Construction, Ashbury General Contracting and Engineering sits at penalty rank #14,673 of 33,222 penalized establishments ($6,075 assessed).
How Ashbury General Contracting and Engineering Compares
Ashbury General Contracting and Engineering's 3.00 violations per inspection compares to the Construction sector average of 3.3 violations per employer.
Against the Construction industry average of $6,767 per employer, this employer's current OSHA penalty sits roughly in line with peers (0.9x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
3
First Inspection
2010-10-01
Last Inspection
2016-04-25
Inspection Span
6 yrs
Violations / Inspection
3.0
Avg Penalty / Inspection
$2,025
Industry Avg / Inspection
$3,361
What this shows 3 inspections over 6 years, averaging 3.0 violations per visit. That's $2,025 per inspection vs. the Construction average of $3,361.
Enforcement detail
Violation Breakdown
1
Serious
11.1% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
8
Other-Than-Serious
88.9% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$16,850
Current Penalty Amount
$6,075
Penalty Reduction
63.9%
What this shows Penalties were reduced by $10,775 from the initial assessment of $16,850. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Construction
How Ashbury General Contracting and Engineering compares to the Construction sector, which has 61,260 employers tracked by PlainWorker.
| Metric | Ashbury General Contracting and Engineering | Industry Avg |
|---|---|---|
| Inspections | 3 | 2.0 |
| Violations | 9 | 3.3 |
| Total Penalty | $6,075 | $6,767 |
| Avg Penalty per Inspection | $2,025 | $3,361 |
Nationwide Construction peers with similar penalties or inspection counts
Two OSHA-record peer sets for Ashbury General Contracting and Engineering, both outside CA so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($6,075 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (3 inspections here).
Nearby & Similar Employers in Construction
Showing 5 of 61259 other employers tracked in this sector.
Compare Ashbury General Contracting and Engineering vs Taylor Morrison of Texas, INC. side-by-side →
What to do with this record
Use Ashbury General Contracting and Engineering's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare Ashbury General Contracting and Engineering against Taylor Morrison of Texas, INC., a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether Ashbury General Contracting and Engineering's inspection and penalty record is typical for Construction or an outlier against the sector's own average. View the Construction sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is Ashbury General Contracting and Engineering safe to work at? ▼
How many OSHA violations does Ashbury General Contracting and Engineering have? ▼
How many OSHA inspections has Ashbury General Contracting and Engineering had? ▼
What is the total penalty amount for Ashbury General Contracting and Engineering? ▼
Does Ashbury General Contracting and Engineering have any serious or willful violations? ▼
What industry does Ashbury General Contracting and Engineering operate in? ▼
Where does Ashbury General Contracting and Engineering rank nationally on OSHA penalties? ▼
How does Ashbury General Contracting and Engineering's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.