Wholesale Trade · West Sacramento, CA
American Metals Corporation
According to OSHA enforcement records (2010–2026), American Metals Corporation ranks #35,304 of 99,447 penalized U.S. employers by total current penalty, with a relatively clean safety record: 2 violations across 2 inspections.
- $9,950
- OSHA penalties
- 2
- Violations cited
- 2
- OSHA inspections
- #35,304
- of 99,447 penalized employers
American Metals Corporation in West Sacramento, CA has been the subject of 2 OSHA workplace inspections and 2 citations since 2010, according to enforcement records from the U.S. Department of Labor. Total penalties assessed: $9,950. All enforcement data below is sourced from the DOL public enforcement databases at data.dol.gov.
The record in one line
OSHA has inspected American Metals Corporation 2 times over 2 years, roughly annually. These inspections resulted in 2 violations, averaging 1.0 per inspection. According to OSHA enforcement records, its total current penalty ranks #35,304 of 99,447 penalized U.S. employers (the upper half of penalized employers nationally). Of these, 1 were classified as serious - indicating hazards that could cause death or serious harm. Against the Wholesale Trade industry average of 2 inspections per employer, this sits roughly in line with peers (1.0x the sector average) on inspection frequency. For comparison, Attic Perfect in San Diego, CA is another wholesale trade employer with 0 OSHA inspections on record and $0 in current penalties.
- 1.0
- violations per inspection
- 50.0%
- of violations were serious
- #35,304
- of 99,447 penalized employers
Compliance score
- C OSHA safety compliance: 2 violations across 2 OSHA inspections (1.0 per inspection), vs. national p10 0.0 (best) / p90 5.5 (worst) among 145,626 inspected employers.
Channels are separate federal datasets: a dimension marked not applicable simply has no record in that dataset for this employer, not a good or bad score.
How American Metals Corporation compares on OSHA penalties
Total current penalty vs the Wholesale Trade per-employer average
- American Metals Corpor…
American Metals Corporation
$9,950 in penalties
- Wholesale Trade avg
Wholesale Trade industry average (per employer)
$9,112 in penalties
What this shows American Metals Corporation sits roughly in line with peers (1.1x the sector average) in total OSHA penalties.
Where this penalty ranks nationally
Total current OSHA penalty vs every U.S. employer with a nonzero penalty
$9,950 Bottom 36% least affordable more affordable than 36% of 99,447 U.S. employers with a penalty
Each bar is a $5K-wide band; taller bars hold more U.S. employers with a penalty. The dashed line + filled bar mark this entry. Hover or tap any bar for its full count, share, and where it sits relative to this entry.
Source U.S. Department of Labor, OSHA enforcement extracts · 2026
Does more inspection scrutiny mean more findings?
Each dot is one of 21 Wholesale Trade employers with an OSHA inspection on record, placed by inspections and violations cited. The highlighted dot is American Metals Corporation.
American Metals Corporation in the Wholesale Trade enforcement ledger
Wholesale Trade sector: American Metals Corporation is the #1,695 heaviest OSHA penalty carrier of 4,429 employers with nonzero fines ($9,950).
How American Metals Corporation Compares
American Metals Corporation's 1.00 violations per inspection compares to the Wholesale Trade sector average of 5.5 violations per employer.
Against the Wholesale Trade industry average of $9,112 per employer, this employer's current OSHA penalty sits roughly in line with peers (1.1x the sector average).
Enforcement detail
OSHA Inspection History
Total Inspections
2
First Inspection
2013-06-14
Last Inspection
2015-09-22
Inspection Span
2 yrs
Violations / Inspection
1.0
Avg Penalty / Inspection
$4,975
Industry Avg / Inspection
$4,665
What this shows 2 inspections over 2 years, averaging 1.0 violations per visit. That's $4,975 per inspection vs. the Wholesale Trade average of $4,665.
Enforcement detail
Violation Breakdown
1
Serious
50.0% of total
0
Willful
0.0% of total
0
Repeat
0.0% of total
1
Other-Than-Serious
50.0% of total
What this shows Serious violations involve hazards that could cause death or serious physical harm. Willful violations indicate intentional or knowing disregard of the law. Repeat violations are for hazards previously cited within the past 5 years.
Enforcement detail
Penalty Analysis
Initial Penalty Assessed
$19,400
Current Penalty Amount
$9,950
Penalty Reduction
48.7%
What this shows Penalties were reduced by $9,450 from the initial assessment of $19,400. Reductions may result from informal settlements, formal contests, or negotiated agreements with OSHA.
Industry Safety Context: Wholesale Trade
How American Metals Corporation compares to the Wholesale Trade sector, which has 6,881 employers tracked by PlainWorker.
| Metric | American Metals Corporation | Industry Avg |
|---|---|---|
| Inspections | 2 | 2.0 |
| Violations | 2 | 5.5 |
| Total Penalty | $9,950 | $9,112 |
| Avg Penalty per Inspection | $4,975 | $4,665 |
Nationwide Wholesale Trade peers with similar penalties or inspection counts
Two OSHA-record peer sets for American Metals Corporation, both outside CA so the neighborhoods are not geographic containment.
Similar current OSHA penalty
Nearest same-sector employers by current assessed penalty ($9,950 here).
Similar OSHA inspection count
Same-sector employers with a comparable inspection history outside this state (2 inspections here).
Nearby & Similar Employers in Wholesale Trade
Showing 5 of 6880 other employers tracked in this sector.
Compare American Metals Corporation vs Fish's Wholesale side-by-side →
What to do with this record
Use American Metals Corporation's enforcement history as one data point, not the whole picture.
- A single employer's record can look unusual in isolation. Compare American Metals Corporation against Fish's Wholesale, a similarly-sized employer in the same sector, before drawing conclusions. Compare side-by-side
- See whether American Metals Corporation's inspection and penalty record is typical for Wholesale Trade or an outlier against the sector's own average. View the Wholesale Trade sector
- Before you accept a job or raise a safety concern, search any employer for its own OSHA inspection history the same way you found this one. Search employers
Figures reflect closed OSHA and WHD federal enforcement actions on record (2010–2026); not every workplace issue results in an inspection or investigation.
Frequently Asked Questions
Is American Metals Corporation safe to work at? ▼
How many OSHA violations does American Metals Corporation have? ▼
How many OSHA inspections has American Metals Corporation had? ▼
What is the total penalty amount for American Metals Corporation? ▼
Does American Metals Corporation have any serious or willful violations? ▼
What industry does American Metals Corporation operate in? ▼
Where does American Metals Corporation rank nationally on OSHA penalties? ▼
How does American Metals Corporation's safety record compare to industry average? ▼
Data Sources & Methodology ▼
Data as of 2026. Source: U.S. Department of Labor (OSHA, WHD).
Source: OSHA Enforcement Data
Inspection and violation records from the Occupational Safety and Health Administration (OSHA), U.S. Department of Labor, covering the period 2010–2026. Includes inspection dates, violation types (serious, willful, repeat, other-than-serious), and penalty amounts. Penalties shown are current assessed amounts and may differ from original citations due to settlement, contest, or reduction.
Source: Wage and Hour Division (WHD)
Compliance actions from the WHD, covering enforcement of the Fair Labor Standards Act (FLSA), including minimum wage, overtime, and child labor violations. Back wages represent amounts owed to affected employees as determined by WHD investigations.
Employer Matching
Employers are matched across OSHA and WHD datasets by name, state, and city. Employers included in PlainWorker have 2 or more OSHA inspections or $1,000+ in WHD back wages. Data is updated monthly from data.dol.gov.